Device Presentation The DSL35L is a compact relay used for protection or regulation. It is entirely configurable via the front face. The measured value is displayed on a 3 digit LED display. Its wide range of temperature and process input makes it a very versatile device.
Note: The hysteresis value is relative to the display range scale and can be configured between 0 % and 99 %. LOREME 12, rue des Potiers d'Etain - 57071 Metz 03.87.76.32.51 - Fax 03.87.76.32.52 - Email: Commercial@Loreme.fr - Technique@Loreme.fr...
Page 5
TABLE OF CONTENTS Configuration 2.3) Delay The delay is configurable from 0 to 60 s and it determines the time above which relay changes its state after event ap- pearance. delay delay Event Relay state ‘ dLY’, The device displays the message pressing the button permit to access the adjustment.
Note: to modify the parameters of terminal mode whereas this one is already started, it is necessary, after having car- ried out the modifications, to close the terminal and to open it again so that the modifications are effective. LOREME 12, rue des Potiers d'Etain - 57071 Metz 03.87.76.32.51 - Fax 03.87.76.32.52 - Email: Commercial@Loreme.fr - Technique@Loreme.fr...
FIRMWARE LOADER Rev0 READY TO TRANSFER... The device is now in the firmware load mode and is waiting for the firmware file. This file is provide by LOREME and contain the firmware code in Intel HEX format. Select the « Transfer », « Send a text file ... » in the HyperTerminal menu.
- It is advisable to separate the input / output lines from the power supply lines in order to avoid the coupling phenomena. - It is also advisable to limit the lengths of data cables as much as possible. LOREME 12, rue des Potiers d'Etain - 57071 Metz 03.87.76.32.51 - Fax 03.87.76.32.52 - Email: Commercial@Loreme.fr - Technique@Loreme.fr...