Parts Included - Haier HT SERIES User Manual

INSTALLATION GUIDE CONT.
LEVELING YOUR REFRIGERATOR
• All four corners of the cabinet must rest firmly on the floor.
• The cabinet must sit level from side to side.
seal properly.
• Turn leveling legs to raise or lower the cabinet.
PROPER AIR CIRCULATION
• o T nsure your refrigerator works at the maximum efficiency it was designed e
for, you should install it in a location where there is proper air circulation,
plumbing and electrical connections. Your refrigerator is not designed to operate
in temperatures below 55˚F (12˚C) or above 95˚F (35˚C).
• Do not install your refrigerator in any loca on not properly insulated or
heated, e.g. garage, etc..
Keep out of direct sunlight and away from hea ng sources such as radiators,
heaters, and cooking appliances.
• The following are recommended clearances around the refrigerator:
Sides and Top...............1" (25mm)
TOOLS NEEDED FOR INSTALLATION
DO NOT USE POWER TOOLS TO INSTALL DOOR HANDLES!
OVERTIGHTENING THE SCREWS COULD STRIP THE THREADS!
Phillips Screwdriver

PARTS INCLUDED

PARTS INCLUDED MAY DIFFER BASED ON UNIT PURCHASED
For mode
screw installed on the faces of the doors, the parts
included will consist of:
• 2 Handles
• 1 Front grille
• 4 Door edge handle
• Owner's manual
Back..................2" (50mm)
Pliers
screws
PAGE 6 • SET UP & USE
5/16 and 3/8 Wrenches or Adjustable Wrench
For models that don't come wit
screw installed on the face of the door, the parts
included will consists of:
• 2 Handles
• 1 Front grille
• 2 Door face handle moun ng screws
• 4 Door edge handle moun ng screws
• 2 Handle cover/trim pieces
• Owner's manual
Front Grille