JVC KD-DV6206 Installation & Connection Manual page 5

B
Connecting the parking brake wire /
When installing the monitor in a location where it can be seen by the driver
Connect the parking brake wire to the parking brake system built in the car.
Parking brake
When installing the monitor in a location where it cannot be seen by the driver
Connect the parking brake wire to metallic body or chassis of the car.
C
Connecting the crimp connector /
Wire connecting the battery and the parking brake switch.
Attach the parking brake wire to this point.
D
Required connections for DVD playback /
Or /
Rear side
KV-MR9010
9-INCH WIDESCREEN MONITOR
(not supplied)
4
*
Only for KD-DV6206/KD-DV6205: To listen to disc playback sound while in Dual Zone operations (see page 32 of INSTRUCTIONS).
* 4
KD-DV6206/KD-DV6205
Parking brake switch
(inside the car)
DVD
Video cord (not supplied)
RCA Pin plugs Stereo mini plug
RCA
When using JVC's KV-MR9010 and KS-HP2, connect
using a conversioncable of this type (not supplied).
JVC KV-MR9010 KS-HP2
KS-HP2
*
Cordless headphones (not supplied)
* 4
32
Parking brake wire (light green)
To metallic body or chassis of the car
Parking brake wire (light green)
Contact the metallic part of the crimp to the wires inside.
Digital optical cable (not supplied)
4
* 4
Headphones (not supplied)
* 4
5
Pinch the crimp firmly.
DIGITAL OUT
See "About sounds reproduced
through the rear terminals."
Audio/video control amplifier or the decoder
compatible with the multichannel digital sources