Advertisement
Lead the LED wiring all the way to the central unit and fasten it in a way that it would
not move or loose. Make sure that the wiring does not restrict the movement of
the steering, your arms or any part of the motorcycle.
Connect the wiring to the central unit of the device. Clean the surface of the loca-
tion where you wish to place the LED strip, then remove the protector foil of the
adhesive and mount the device to the selected spot. The next step is to drill a hole
for the status indicator and mount the device.
d) Finding the location of the GPS receiver
For the best efficiency, make sure that the GPS receiver has a clear view to the sky.
Metallic surfaces might interfere with the connection between the GPS receiver
and the satellites, therefore make sure that no such parts are above the antenna.
Lead the wiring of the receiver all the way to the central unit and fasten it in a way
that it would not move or loose. Make sure that the wiring does not restrict the
movement of the steering, your arms or any part of the motorcycle. After it, connect
the cable of the GPS receiver to the central unit.
e) Installing the GPS detector
Connect the black cable of the central unit to the battery's negative terminal or to
chassis. After this, connect the red cable to a point where a +12V voltage is present
following the ignition. The device includes a fuse that will cut off the current in case
of a malfunction or a short wire, but will automatically turn back on 30 minutes after
the malfunction ceases. Therefore, there is no need for additional fuses attached
to the red cable
3
Advertisement
