Advertisement
Quick Links
Specification
Product
Power Supply
Working Current (Max)
Signal Transmission Format
Signal Output
Electrical Status
Transmission Distance
Dimension
Weight
What's Included
Emitter
1pc RJ45 Adapter Cable
Receiver / Probe
1pc User's Manual
Earphone
1pc
08
PITS-TP-2
DC, 9V Battery (2)
Emitter ≤ 10mA
Receiver ≤ 30mA
Multi-frequency impulse
8Vp-p
≥ 6,561ft (≥ 2km)
Emitter: 126 x 49 x 34mm
Receiver: 175 x 42 x 27mm
Set: 270 x 165 x 45mm
0.93 lb.
1pc
1pc
Advertisement
Related Manuals for Gearmate PITS-TP-2
Summary of Contents for Gearmate PITS-TP-2
- Page 1 Specification Product PITS-TP-2 Power Supply DC, 9V Battery (2) Emitter ≤ 10mA Working Current (Max) Receiver ≤ 30mA Signal Transmission Format Multi-frequency impulse Signal Output 8Vp-p Electrical Status Transmission Distance ≥ 6,561ft (≥ 2km) Emitter: 126 x 49 x 34mm Dimension Receiver: 175 x 42 x 27mm...
- Page 2 Adjust the DIP switch on the emitter to “Scan” position, if the Low Voltage larm battery level is lower than 6V, “Status” and “Verify” indicators will light up simultaneously. The battery needs to be switched out to a new 9V battery. Table of ontents Use earphones in noisy settings to Earphones prevent outside interference for precise...
- Page 3 Other Functions Interface and Functions Open Circuit or Short Circuit Testing Adjust the DIP switch on the emitter to “Test” position, then press the function switch on the emitter for 2 seconds, the “Verify” indicator will go from flashing to solid. Connect the Probe crocodile clamp to the RJ11 port, clamp the two ends of the RJ45 Port...
- Page 4 Telephone Cable Tracing Function Network Wire Collation Function 1. Insert the two ends of a networking cable into the RJ45 ports of the emitter and receiver. 2. Push function switch button on emitter to the position of “TEST”, testing indicator “VERIFY” will flash which indicates that the emitter 1.
- Page 5 Electrical Wire Tracing Function Networking Cable Tracing Function 1. Directly insert RJ11 of crocodile clip into RJ11 port of emitter, 1. Directly insert networking cable with RJ45 plug into RJ45 port of connect telephone line with the clamp. emitter. 2. Push DIP switch on emitter to “SCAN” position. Wire locator 2.