Existing Windows Me Installation; Confirming Windows Me Driver Installation - Promise Technology 150TX2 User Manual

Existing Windows ME Installation

The following section details the installation of FastTrak TX2plus drivers on a
system that has Windows ME already installed and running.
1. After installing the FastTrak S150 TX2plus controller card and configuring
the hard drives, power up the system and boot.
2. The Add New Hardware Wizard will appear, informing you that it has found
a PCI Mass Storage Controller.
3. Click Next, then from the generated list box, choose Specify the location of
the driver (Advanced).
4. Click Next, then from the generated choices, choose Specify a location.
5. Insert the FastTrak TX2plus driver diskette in drive A:.
6. Type A:\WIN98-ME in the text box that appears.
7. Click Next. A message informing you that Windows Me has found "Win98-
ME Promise FastTrak TX4000/S150 TX Series Controller" should appear.
8. Click Next, then click Finish. When asked if you want to restart your
computer, click Yes. Immediately remove the diskette from drive A:.

Confirming Windows ME Driver Installation

To confirm that the driver has been properly loaded in Me, perform the following
steps:
1. Choose Settings from the Start menu.
2. Choose Control Panel, then double-click the System icon.
3. Choose the Device Manager tab, then click the "+" in front of SCSI & RAID
controllers. "Win98-ME Promise FastTrak TX4000/S150 TX Series
Controller" should appear.
Chapter 4: Installing Software Drivers
45