Dell S300 User Manual page 42

Hide thumbs Also See for S300:

Table of Contents

3D D

Network—Select On to activate network function. Press

settings.

NETWORK

The Network menu allows you to configure the network connection settings.

DHCP A

connected, the IP address will automatically be acquired when you select DHCP

On. If DHCP is Off, manually set the IP Address, Subnet Mask, and Gateway. Use

Enter to confirm each number and then use

T H E T R U S T E D S O U R C E F O R P R O J E C T O R L A M P S A N D A C C E S S O R I E S

—Select On to start the 3D display function. Default is Off.

ISPLAY

NOTE:

To activate 3D Display function, ensure that 3D goggles, 3D video

contents and 60Hz/120Hz signal output graphic card supported on PC/NB are

ready.

If you see a discrete or overlapping image while

3D Sync Invert—

wearing DLP 3D goggles, you may need to execute 'Invert' to get

best match of left/right image sequence to get the correct image.

(For DLP 3D goggles)

—If a DHCP server exists in the network to which the projector is

DDRESS

to select the number of IP Address, Subnet Mask, and Gateway. Key in

to configure Network

to set the next item.

Using Your Projector

Table of Contents