Advertisement
Attach Tetra Contour to the mounting
4
clips, leaving a 3/8 in. (10mm) gap
between sections to allow for expansion
or contraction. Secure light guide by
twisting tie-wire around the mounting
clip and light guide.
Weather box can be painted
Insert wire connectors into weather
7
box. Fill with electrical grade silicone
and close box. Weather box can be
mounted using #8 (M3) screws.
NOTE: Weather box is required for all
outdoor electrical connections.
Example electrical grade silicones include: GE RTV 6700 Series Silicone Rubber Adhesive Sealant, GE White Blanc RTV 162 Silicone
Rubber Adhesive Sealant-Electrical Grade, Dow Corning 3140 - Non-Corrosive Flowable (clear), Dow Corning 3145 - Non-Corrosive
Nonflowable (clear or gray) & Dow Corning RTV 748 Non-Corrosive Sealant-White
Connect Power Supply
To Tetra Contour
Black (-)
Power
supply
Run a wire from the power supply to
1
a section of Tetra Contour.
NOTE: Power supply connection
must be completed in an acceptable
UL/NEMA enclosure.
NOTE: Power supply loading is
described in the power supply
installation instructions.
WARNING
Risk of electrical shock. Turn power OFF
before inspection, installation or removal.
3/8in. (10mm)
Separate wires and identify outer
5
conductors as positive (+) and
middle conductors as negative (–).
Strip ends back 0.5 in. (13mm).
At each gap between Tetra Contour
8
sections, snap on a GExxLGC15 light
guide connector.
Red (+)
+
Separate wires and identify outer
2
conductors as positive (+) and middle
conductor as negative (-). Strip ends
back 0.5 in. (13mm).
Separate wires
+ + –
–
+
+
Electrical grade silicone
+
–
Connect two
Connect four
positives (+)
negatives (–)
Use twist-on wire connectors to join
6
wires together. Fold wires behind
light engines.
Electrical grade silicone
At any open end, apply electrical
9
grade silicone and press fit a
GExxLGEC15 light guide end cap to
the Tetra Contour.
Outer wires (+)
Middle wire (-)
Red (+)
Black (-)
To power supply
Connect the two outer wires (+) from
3
the LED strip to the red wire (+) of the
power supply. Connect the middle
wire (-) from the LED strip to the black
wire (-) of the power supply.
NOTE: Grounding and bonding must
be done in accordance with National
Electrical Code (Article 600). See
power supply instructions.
Advertisement
