THE INSTALLER PRIOR TO INSTALLATION TO ENSURE THAT NO DAMAGE OCCURRED IN TRANSIT AND THAT A DAMAGED PART IS NOT USED. PROPER INSTALLATION CANNOT BE OVERSTRESSED, IMPROPER INSTALLATION VOIDS S.R. SMITH’S WARRANTY AND MAY AFFECT THE SAFETY OF THE USER.
PARTS LIST Item # Part # Description Qty. 03-500 FOOTREST & STEP, TOP 03-501 SEAT & BACK PLATE 03-502 SEAT SUPPORT, SIDE 03-503 SEAT SUPPORT, REAR 03-504 SEAT SUPPORT, CENTER 03-505 SEAT SUPPORT, FRONT 03-506 BACK SUPPORT, RIGHT 03-507 BACK SUPPORT, LEFT 03-508 30"...
Page 6
Visit srsmith.com for hardware kit and replacement part information.
ASSEMBLY INSTRUCTIONS Tools Required 1. #2 Square Drive Bit 5/32” Allen Wrench 7/16” Ratchet or Wrench Lifeguard Stand Assembly 1.Attach part (2) to part (3) as shown using screws (34). 2.Attach part (3) to assembly using screws (34).
Page 8
3.Attach part (4) to assembly with screws (34). 4.Attach part (5) with notch in direction shown to assembly using screws (34). 5.Attach part (6) to assembly with screws (34).
Page 9
6.Seat Bottom Assembly should look like the pictures below when finished. Next make Seat Back Assembly. 7.Attach part (2) to part (8) using screws (34). 8.Attach part (7) to assembly using screws (34).
Page 10
9.Seat Back Assembly should look like the pictures below when finished. Next make Footrest Assembly. 10.Attach part (20) to part (18) using screws (34). 11.Attach part (19) to assembly using screws (34). 12.Attach part (17) to assembly using screws (34).
Page 11
13.Attach part (1) to assembly using screws (34). 14.Finished Footrest Assembly should look like the picture below. Next attach legs using last 3 assemblies. 15.Attach Seat Back Assembly, Seat Bottom Assembly, and Footrest Assembly to leg (11) as shown using nuts (35), washers (36), and screws (37).
Page 12
16.Next, attach leg (9) to assembly using nuts (35), washers (36), and screws (37). 17.Flip chair and attach leg (12) to assembly using nuts (35), washers (36), and screws (37).
Page 13
18.Next attach leg (10) to assembly using nuts (35), washers (36), and screws (37). 19.Now attach left arm (31) to assembly using screws (34).
22.Now install umbrella mount (28) using screws (34). 23.Screw in thumb screw (38), do not tighten.
Page 16
24.Install Anchor (39) using Bolt (33), Washer (36), and Nut (35). 25. Assembly complete. Now, go back through assembly to ensure all hardware has been properly tightened. Warning: Chair required to be anchored to deck when using umbrella. Recommended Anchor: When installing in concrete use type 316 stainless steel concrete anchor, 3/8”...