Fcc Guidelines/Documentation - ikeGPS IKE 4 User Manual

FCC Guidelines/Documentation

FCC Information
1520894-003
Model: IKE-IK04-L
This device complies with Part 15 of the FCC Rules.
Bluetooth Information
FCC ID: 2ACBG4000
IC ID: 11952A-4000
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes of modification to this unit not expressly
approved by party responsible for compliance could void the
user's authority to operate the equipment. Note: This equipment
has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Industry Canada
This device complies with Industry Canada's licence-exempt RSSs.
Operation is subject to the following two conditions:
• This device may not cause interference; and
• This device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes:
• l'appareil ne doit pas produire de brouillage;
• l'utilisateur de l'appareil doit
radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Note:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own
expense
Changes or modifications not expressly approved by ikeGPS could void the user's authority to operate the equipment.
64
accepter tout brouillage
This equipment complies with FCC/IC radiation exposure limits
set forth for an uncontrolled environment and meets the FCC radio
frequency (RF) Exposure Guidelines in Supplement C to OET65
and RSS-102 of the IC radio frequency (RF) Exposure rules. This
equipment has very low levels of RF energy that are deemed to
comply without testing of specific absorption ratio (SAR)
Class 1M Laser Product
IEC60825-1:2014 (3rd Edition)
Caution: This instrument emits a non-visible laser beam. The laser
beam emitted is Laser Class 1 per IEC 60825-1 and complies with
21 CFT 1040.10 and 1040.11 except for deviations pursuant to
Laser Notice 50, date June 24, 2007
Caution: Hazardous Radiation. Use of controls or adjustments or
performance of procedures other than those specified herein may
result in hazardous radiation exposure.
Caution: while the laser tool s in operation, be careful not to expose
your eyes to the emitting laser lens. Exposure to a laser beam for
an extended time may be hazardous to your eyes.
Warning: the following label samples are placed on your laser tool
to inform of the laser class for your convenience and safety. Please
reference the Product Manual for the specifics on a particular
product model.
IKE 4 User Manual