Related Manuals for TRONTEQ Electronic Qiwi Lite
Summary of Contents for TRONTEQ Electronic Qiwi Lite
-
Page 1: User Manual
User Manual Industrial Ethernet Switch Lite Managed Qiwi Lite Order No.: 006-120-101 User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 1 von 31... - Page 2 Any other use which goes beyond in particular copying, reproduction, translation requires written consent of TRONTEQ Electronic. TRONTEQ Electronic reserves the right to modify the contents of this manual. In addition, we refer to the conditions of use specified in the license agreement.
- Page 3 Firmware update via USB flash drive .................. 27 11. Help Menü ............................. 28 12. Technical data ..........................29 12.1. Electrical ..........................29 12.2. Mechanical .......................... 30 12.3. Environment ........................30 13. Licenses ............................30 User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 3 von 31...
- Page 4 User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 4 von 31...
-
Page 5: Safety Instructions
ATTENTION! Indicates that minor personal injury can result if proper precautions are not taken. CAUTION! Hint for useful tips and recommendations for efficient and trouble-free operation. User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 5 von 31... -
Page 6: Qualified Personnel
However, the information in this publication is reviewed regularly and any necessary corrections are included in subsequent editions. 1.6. Disposal The device should be disposed of after use in accordance with the current disposal regulations as electronic waste. User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 6 von 31... -
Page 7: Device Description
2.1. General The Qiwi Lite Ethernet Switch is designed for industrial application specially fabric automation. The Switch features a Lite Management software with a build in web interface for configuration purposes. With the Lite Management concept this product is the perfect solution where unmanaged Switches haven’t enough configurations and Full Managed Switches are too expensive and have not needed... -
Page 8: Interfaces
2.4. Interfaces Below is a picture of the Qiwi Lite Switch Digit Description System-LEDs: PWR = Power, MOD = Mode, ERR = Error, DI = Digital Input Connection for power supply, fault contact, Digital Input USB Port Ethernet Port with Port-LEDs: LA = Link, SP = Speed... -
Page 9: Connecting The Power Supply
The connection is performed with the RJ-45 jacks (8P8C) of the device. Assignment Connection Image Data TX+ Data TX- Data RX+ Not connected Not connected Data RX- Not connected Not connected User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 9 von 31... -
Page 10: First Start-Up
4. Start the web browser and enter the LAN-IP address of the device 5. Perform the desired configuration of the device 6. Connect the switch with your network devices User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 10 von 31... -
Page 11: Configuration With Web Interface
The default access is configured as follows: User: admin Password: password If in the network Broadcast packets are sent permanently through the Switch, the web interface may be unreachable. User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 11 von 31... - Page 12 After logging in at first the dashboard appears which shows a detailed overview and already provides initial information on the state of the network port. In addition, this page contains a graph showing the connections of the device. User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016...
-
Page 13: Settings Of The System
3 are prioritized. With “Link Status” ports can be activated or shut down. Deactivating of unneeded ports is recommended if a link-down event should be monitored (see section 7.2). User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 13 von 31... -
Page 14: Port Mirroring
The table on the right side defines which ports and traffic, incoming/outgoing, should be mirrored to the destination port. To confirm the settings click on the “set” button. User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 14 von 31... -
Page 15: Link Aggregation
Each interface can be assigned to Group A or Group B. To confirm the settings, click on the “submit” button. Max. 2 groups are supported by the device. The connected devices must be configured for Link Aggregation. User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 15 von 31... -
Page 16: Vlan
The following image shows the configuration of two VLAN network consisting of ports 1, 2, 3, 4 and 5, port 6 is in both network. Therefore ports 1, 2, 3 can’t transfer data to ports 4, 5. Port 6 is connected with all ports. User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016... - Page 17 If different VLANs are wired, problems with data transfer occur. It is recommended to configure one common VLAN. User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 17 von 31...
-
Page 18: Device Diagnosis
Active network port has no data connection = Link Down. Config The loaded configuration file is invalid. 32, 64, 128 Internal Internal device fault. Digital input is triggered. User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 18 von 31... -
Page 19: Fault Contact
If there are one or more active trigger events, the Fault Contact stays active. The electrical features of the Fault Contact are described in chapter 12.1Fehler! Verweisquelle konnte nicht gefunden werden., the connection in chapter 3.3. User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 19 von 31... -
Page 20: Trap
As trigger for Traps one or several of the following fault statuses can be configured: ► Power (active as default) ► Temperature (active as default) ► Linkdown (active as default) ► Internal (active as default) ► Digital Input User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 20 von 31... -
Page 21: Diagnosis Services
30001 (decimal) and an offset. The names and description are ASCII coded thereby a word has to characters. Not used characters are filled with 0x00. The offsets are displayed as hexadecimal digits in the following table. User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016... - Page 22 Description (ASCII Format) It is possible to read multiple registers at once. It is important that there are no invalid ranges, because then the request will be answered with a fault. User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 22 von 31...
-
Page 23: Digital Input
All logging files can also be downloaded on a USB flash drive. Therefore browse to Maintaining > Settings and check the box of “Logging Files” in the first menu “Copy to USB”. User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016... -
Page 24: Configuration System Access
The configuration is performed in the web interface at Configuration > Admin Interfaces. Deactivated ports can’t be set as administration ports. Therefore the user can’t be locked out. User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 24 von 31... -
Page 25: Password Change
USB flash drive („config.cfg“), as a Upload from a PC ► Load default settings Configuration files can be loaded and applied automatically from a USB flash drive, see chapter 9. User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 25 von 31... -
Page 26: Configuration With Usb Flash Drive
USB flash drive must be present. The configuration file must be "confignew.cfg". After plugging the USB flash drive into the switch, the device will load automatically the new configuration file and apply it after the successful authentication. User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016... -
Page 27: Firmware Update
The firmware update will start automatically after the USB flash drive is connected to the device. During this process the MOD LED flashes as described in section 7.1. User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016... - Page 28 Click on „Open as site and info as pop-up“ and you will get to the web site of the actual term. The help information text will appear in a pop-up window. User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016...
-
Page 29: Technical Data
Packet size 64Byte – 1518Byte Throughput Multicast- Packet Full wire speed Packet size 64Byte – 1518Byte Packet size without VLAN Tag 1518 Byte with VLAN Tag 1522 Byte User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 29 von 31... -
Page 30: Mechanical
13. Licenses The firmware of the Qiwi consists of files that are licensed, one part is Open Source. The following table shows the used Open Sources projects and the associated licenses. User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 30 von 31... - Page 31 Software / Project Version Licenses FreeRTOS 7.0.0 GPL2 + MODIFIED BY the FreeRTOS exception 3.21.0/3.18.1 Atmel ASF license lwIP axTLS 1.5.2 User Manual Qiwi Lite Support: www.tronteq.de/support Release 11/2016 Seite 31 von 31...
Need help?
Do you have a question about the Qiwi Lite and is the answer not in the manual?
Questions and answers