Installing The Transceiver - ComSpace Odyssey 2000 Instruction Manual

The 800mhz dc/ma mobile radio including direct frequency assignment (dfa) with digital ltr trunking
Table of Contents

Advertisement

Instruction Manual
2. Run the two power cable leads from the passenger compartment through the firewall
and into the engine compartment.
3. Select a location in the two power cable leads for the fuse holder location and cut
each wire at that location.
• Locate the fuse as close to the battery as possible
4. Strip insulation from each end of the two power cable leads that have been cut
(approximately 3/8-inch).
5. Insert wire in fuse holder.
6. Crimp terminal through body.
7. Repeat steps 5 and 6 for other half of the holder and for the holder on the second
power cable lead.
8. Insert fuses in each holder.
9. Snap housing for the two holders together being cautious to keep the holders for the
red lead and the holders for the black lead together.
10. Connect the red lead to the positive (+) battery terminal and the black lead to the
negative (-) battery terminal.
11. Recoil and secure the surplus power cable.
• Be sure to leave enough slack in the cables so that the transceiver can be removed
for servicing while keeping the power applied.

INSTALLING THE TRANSCEIVER

WARNING! FOR PASSENGER SAFETY, THE TRANSCEIVER MUST BE INSTALLED
SECURELY. USE THE SUPPLIED MOUNTING BRACKET TO MOUNT THE
TRANSCEIVER.
1. Mark the position of the holes in the dash or other location of the transceiver within
the passenger compartment by using the mounting bracket as a template. Drill 0.196
inch holes and attach the mounting bracket using the supplied #12-24 thread cutting
screws.
• For user convenience and safety, be sure to mount the transceiver in a location
where the user can easily reach the controls. Also, be sure that there is sufficient
clearance to provide cable clearance for both front and rear and side clearance for
the installation of the thumbscrews that hold the transceiver in the mounting
bracket.
2. Insert the Accessory Plug into the Accessory Connector.
3. With an antenna mounted in compliance with the warning provided in this manual,
connect the antenna and the supplied power cable to the transceiver rear.
Page 12 of 25

Advertisement

Table of Contents
loading

Table of Contents