Assembly - ProForm AT 500 PFTL49906.0 User Manual

3/4" Tek Screw (58)–8

ASSEMBLY

To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480. Assembly
requires two persons. Set the treadmill in a cleared area and remove the packing materials; do not dispose of the
packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
high-performance lubricant. During shipping, lubricant may be transferred to the top of the walking belt or to the
shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top
of the walking belt, wipe it off with a soft cloth and mild, non-abrasive cleaner.
Assembly requires the included hex keys
mallet , adjustable wrench
To identify assembly hardware, see the drawings below. The number in parentheses below each drawing is the
key number of the part, from the PART LIST on page 23. The number following the parentheses is the quantity
used in assembly. To avoid damaging plastic parts, do not use power tools for assembly.
Silver Ground
Screw (10)–2
Handrail Bolt (9)–4
Upright Bolt (4)–4
Wheel Bolt (5)–2
Frame Bolt (1)–2
1. Attach a Wheel (74) to one side of the Base (37)
with a Wheel Bolt (5), two Wheel Spacers (94),
and a Wheel Nut (90) as shown. Do not over-
tighten the Wheel Nut; the Wheel should turn
freely.
Attach the other Wheel (74) to the other side
of the Base (37) in the same way.
Attach the four Base Pads (51) to the Base (37)
with four 1 1/2" Screws (66); make sure that the
screws are in the indicated holes in the Base.
and your own phillips screwdriver
1/2" Screw
1 1/2" Screw (66)–4
(83)–8
Screw (90)–2
, and needlenose pliers
Wheel Nut (90)–2
3/4" Screw (3)–6
Nut (12)–2
Console
Bolt (2)–2
1
74 94
94
66
5
Hole
66
Hole
6
1/2" Screw (119)–1
.
1/4" Star Washer
Handrail Star
Washer (11)–4
Upright Washer
(7)–2
Wheel Spacer
Upright Star
(94)–4 Washer (6)–4
74
66
Hole
90
37
51
66
Hole
51
, rubber
(8)–2
51
51