Play Discs - Philips MCM1006 User Manual

4 Play discs

1
Slide the power switch and source selector
to CD.
2
Lift the cover of disc compartment.
3
Load a disc with the printed side facing
upwards.
4
Close the cover of disc compartment.
» Play starts automatically after a few
seconds.
• If play does not start automatically,
press to start play.
Control play
During play, follow the instructions below to
control play.
Buttons Function
Start or
resume play.
Pause play.
Stop play.
/
Press to skip to
the previous or
next track.
/
Press and hold
to rewind or
search forward
fast within a
track.
ALBUM -
Skip to the
ALBUM + previous or
next album
when no less
than one
album exists.
LCD
displays
the track
number, ,
and
the track
number,
, and
(blinking)
the total
number
of tracks
and
the track
number, ,
and
the track
number, ,
and
the track
number,
ALB, and
Program tracks
Note
•
You can program a maximum of 20 tracks.
•
During programming, if no operation is made within
20 seconds, the system returns to stop mode without
saving programmed tracks.
For a CD
1
Press to stop play.
» The total number of tracks is displayed.
2
Press PROG to activate the programming.
» PROG is displayed, and
3
Press /
to select a track.
» The track number blinks.
4
Press PROG again to program the selected
track.
5
Repeat steps 3 and 4 to program more
tracks.
6
Press to start play.
For a WMA/MP3 disc
1
Press to stop play.
» The total number of tracks is displayed.
2
Press PROG to activate the programming.
» PROG is displayed, and
3
/
Press
repeatedly to select an album.
» The album number and ALB blinks.
4
Press PROG again to confirm the selected
album.
» A track number is displayed, and ALB
disappears.
5
/
Press
repeatedly to select a track.
blinks.
(or ALBUM - /ALBUM +)
blinks.
(or ALBUM - /ALBUM +)
(or ALBUM - /ALBUM +)
EN 7