Turning On The Clearreader - Optelec ClearReader+ User Manual

+
Optelec ClearReader
+

Turning on the ClearReader

+
To turn on the ClearReader , press the round Power button on
the right-hand side. The start-up process will take approximately
40 seconds. You will hear a series of beeps to indicate that the
+
ClearReader is starting up followed by the start-up sound. Now
+
the Power indicator is lit up and the ClearReader is ready to use.
Standby mode
+
The ClearReader will go into standby mode by pressing, and
holding down the Back button and Forward button for 2 seconds.
+
The standby sound will be played, the Power indicator will start blinking and the ClearReader will
+
go into standby mode. To wake up the ClearReader from standby, press the Power button. When
+
the batteries are fully charged, the standby time of the ClearReader is approximately 40 hours.
+ +
After 40 hours the ClearReader will power down. If switching-on the ClearReader from the
standby mode, the start-up process will take approximately 10 seconds.
+
Turning off the ClearReader
+
Press the Power button to power down the ClearReader completely. The power down sound will
be played and the Power indicator will turn off.
English Page 14