ProForm 831.297771 User Manual page 6

Proform user's manual 595le treadmill 831.297771
Table of Contents

Advertisement

4. While a second person holds the Right Handrail (85) and
the Console Base (87) near the right Upright (82), cut the
indicated plastic ties off the Right Handrail. Do not cut
the other plastic tie off the Right Handrail. Next, cut
the plastic tie off the Upright Wire Harness (34) in the
right Upright (82). Do not drop the Upright Wire
Harness into the right Upright.
Refer to the inset drawing. Connect the Upright Wire
Harness (34) to the Console Wire Harness (48). The
latch on the Console Wire Harness should snap onto the
Upright Wire Harness. If the Wire Harnesses do not fit
together easily, turn them; do not force the Wire
Harnesses together. Next, connect the right pulse wire
(with the ÒRÓ tag), the left pulse wire, and the ground wire
to the corresponding connectors on the Console Wire
Harness (48); make sure that the wires with tags are
connected to each other.
5. Note that there is still a plastic tie in the Right
Handrail (85); do not remove this plastic tie.
Position the Right Handrail (85) on the right Upright (82)
as shown. The bracket on the base of the right Upright
should be inside of the lower end of the right Handrail, as
shown in the inset drawing.
While holding the Console Base (87) near the Right
Handrail (85), feed the Console Wire Harness (48) into
the Right Handrail. Next, place the Console Base on the
Handrails (74, 85). Insert any remaining Console Wire
Harness into the Right Handrail.
Thread two Handrail Bolts (78) with Handrail Washers
(36) into the Left Handrail (74) and the left Upright (82) as
shown. Do not tighten the Handrail Bolts yet. Next,
thread two Handrail Bolts (78) with Handrail Washers
(36) into the Right Handrail (85) and the right Upright
(82). Do not tighten the Handrail Bolts yet. Be careful
to avoid damaging the Console Wire Harness (48).
6. Attach the Console Base (87) to the Left and Right
Handrails (74, 85) with four Long Screws (114).
Refer to assembly step 5. Tighten the four Handrail
Bolts (78) used in assembly step 5.
Press two Small Upright Plugs (79) into the holes near
the upper ends of the Uprights (82).
7. Remove the backing from the Adhesive Clip (99). Press
the Adhesive Clip onto the base of the right Upright (82)
as shown. Press the Allen Wrench (100) into the
Adhesive Clip.
8. Make sure that all parts are tightened before you
use the treadmill. To protect the floor or carpet, place
a mat under the treadmill.
4
87
Cut
Plastic
Ties
48
5
78
36
82
36
6
87
114
74
7
6
Do not
cut
Right Left Ground
85
Cut Plastic Tie
34
82
87
Remove
48
78
36
82
74
Bracket
78
79
85
82
82
100
99
48
34
Do not
this
Plastic
Tie
85
85
114

Advertisement

Table of Contents
loading

This manual is also suitable for:

595le

Table of Contents