Usb Connector - Omega OM-USB-2404-60 User Manual

OM-USB-2404-60 User's Guide

USB connector

The USB connector provides +5 V power and communication. The voltage supplied through the USB connector
is system-dependent, and may be less than 5 V. No external power supply is required.
LED
The LED indicates the device status. When connected to a USB port, the LED blinks steadily to indicate that
the device is initialized and receiving power. Refer to the following table for the possible LED states.
LED State
Off
Continuous single-blink
Continuous double-blink
Strain relief slot
Use the strain relief slot to keep the USB cable from disconnecting from the device inadvertently. Feed a tie
wrap through the slot and secure to the USB cable when it is connected to the device.
High-voltage applications
For high voltage applications, we recommend using the OM-ACC-160 backshell to ensure that the terminals are
not accessible. The backshell also provides strain relief to protect the screw terminals.
Signal source connections
You can connect ground-referenced or floating signal sources to the OM-USB-2404-60.

Connect the positive signal of the signal source to the CH+ screw terminal.
 Connect the negative signal of the signal source to the CH – screw terminal.
The following figures show the connections between the OM-USB-2404-60 and both a grounded signal source
and a floating signal source.
LED states
device status
The device is not connected to a USB port or hub.
The device is operating normally.
The device is connected to a USB 1.1 Full-Speed port or hub, which may affect
performance.
Optimum performance requires connections to a USB 2.0 Hi-Speed host controller
(480 Mbps) and USB 2.0 high-speed hubs.
Figure 4. Connector backshell (OM-ACC-160 accessory)
Figure 5. Connecting a grounded signal source
9
Functional Details