Advertisement
l With certain types of stain, which occur less frequently, it is necessary, in spite of the increased danger of formation of
ring marks, to wet the stain before treatment with a few drops of methylated spirit, Together with dissolved staining
substance can be removed by spraying with fluid from TEX-90.
l This treatment can be recommended for the following types of stains: Special oils based on molybdenum sulphide,
tallow, wax, ballpoint pen ink, make-up, stamp pad ink and also in some cases stains caused by fruit juices.
l If spraying through the material is not possible, then cleaning is carried out by spraying tangentially across the surface. In
this case always work with a soft, fine mist spray.
l All types of yarn packages and especially con bobbins can be successfully cleaned in this way, even if the soiled area is in
the bulge or dent. Should it be necessary to clean carpets, structured fabrics, mohair, velour or any napped fabric, the
soiled material can be laid over a round cushion or over the arm of the operator. In this way the stain is rinsed tangentially
out of the material.
l Sedimentary stains, which have formed a crust on one side of fabric, should be cleaned from the back.
l The removal of continuous and needle-shaped stains from plain fabrics is easy, economical and therefore to be
recommended.
l Stains caused by specialized technical oils or greases, or those which have worked into the fabric over a lengthy period,
should first of all be treated by applying a trace of fluid using the fine mist spray, in order to somewhat soften the staining
substance. Do not make thoroughly wet: spray only a very thin layer.
l Where possible, crusts should, first of all, be scraped off with the dull edge of a knife blade. The spray jet should if possible
be kept at a right-angle to the material, in order to reduce danger of thread displacement.
l Spraying of thick fabrics, treated with moisture-repellant, should be carried out when they are lying flat, and stretched, if
possible. If they are freely supported, fluid can escape downwards too quickly.
l Production machines (ring travelers, shuttle-boxes, loom reeds, needle beds, sewing machines, and machines and
motors in general) can be treated and kept clean using this process.
l Moth repellant and impregnating agent can also be sprayed. However, these fluids are nearly always very corrosive, and
for this reason the stain remover must be cleaned immediately after use.
l It is advised that a separate container is used for each type of fluid.
Dear Customer,
It is in your own interest to ensure that the enclosed Warranty Card is filled in & stamped by the dealer at the time of
purchase. For warranty conditions, please refer below.
We guarantee this appliance on the following terms:
We will carry out free repairs or replacement of all parts that are found to be defective owing to design or manufacturing flaws. This
warranty does not extend to damage caused by improper assembly or usage, normal wear & tear, negligent handling or servicing, or
damage owing to chemicals, electrochemicals, electric agents and particularly abrasive or corrosive materials not recommended by
us.
For the warranty to be valid, the card has to be stamped by the dealer as per provision, with the date of purchase and his signature. Also,
the appliance has to be returned with the completed warranty card.
We reserve the right to entrust compliance with the warranty to our approved sub-contractor / dealer. If inspection reveals that the
damage is not covered by this warranty, repairs will be carried out at the expense of the purchaser.
Terms & conditions of Warranty
Yours faithfully,
Ishwar S. Manik
Managing Director
Advertisement
