Table of Contents
Advertisement
Installation
IMPORTANT:
COMPLETED
BAUMATIC ONLY SANCTION THE INSTALLATION GIVEN
IN THIS INSTRUCTION MANUAL. YOU SHOULD KEEP
THE TRANSIT PACKAGING, IN CASE YOU NEED TO
TRANSPORT THE MACHINE IN THE FUTURE.
Installing the appliance
o Your dryer is provided with a vent hose which will extend to
approximately 1.8 metres. It is strongly recommended that this is
vented through a wall or window with the attachment provided.
o This appliance is NOT designed to be built-in, however, if required
you should cut a hole for the vent hose (100 mm diameter) directly
behind the appliance opposite the vent exhaust hole in order to lay
the extraction hose without kinking it.
IMPORTANT: THIS APPLIANCE MUST NOT BE BUILT-IN.
o If the vent through the wall is to be positioned anywhere else other
than behind the dryer, the vent hose should be located at floor level
and through an adjacent side panel to a suitable position.
o IMPORTANT: The air vents at the back of the appliance must
never be covered or blocked in any way as this will cause the
dryer to overheat. You MUST leave a gap of at least 2cm at
the back of the appliance.
THIS
INSTALLATION
BY
A
SUITABLY
MUST
QUALIFIED
PERSON.
BE
19
Advertisement
Table of Contents
