Power Cable Connection; Signal Cable Connection - MAG Technology LA810E Operation Manual

1 To insure a smooth installation, reinstall the Standard (VGA) graphics
adapter driver through Control Panel / Display / Settings and set the
display resolution to 1280 x 1024.
2 Power off the computer and display, then disconnect the display cable
from the back of your computer.
3 Remove the computer cover. If necessary, consult your computer' s
manual for help.
4 Discharge your body's static electric charge by touching a grounded
surface, such as the metal surface of the computer chassis before
touching your computer boards or the graphic adapter card.
5 If your computer has uses an on-board built-in graphics adapter, you
may need to disable it.
6 If your card is a PCI card, install it in a PCI slot. If your card is an
AGP, install it in an AGP slot. If necessary, remove the metal cover
from the expansion slot. Align your card with the expansion slot and
press firmly until the card is fully seated.
7 Replace the screw to fasten the card in place, and replace your
computer' s cover.
8 Once you have completed the card and video driver installation, return
to Control Panel / Display / Settings, and reset the display resolution
and colors to your preferred settings.
For more detailed instructions, open the file \ati\online\english\start.pdf on
the MAG PanelVision Software CD-ROM with a PDF reader. If you do not
have a PDF reader, you may download one from

Power Cable Connection

Connect the female end of the power cable to the power input receptacle on
the power adapter. Plug the power cable into the wall outlet. Plug the other
end of the power adapter into the DC-IN jack of the monitor.

Signal Cable Connection

Plug the PanelVision digital signal cable into the digital signal connector on
the video display card.
LA810E.p65 10
www.adobe.com
2000/8/14, PM 03:02