Advertisement
Service and Installation Manual
INSTALLATION
Make sure that the freezer is not damaged on arrival. Your supplier must be notified of any transport
damage within 24 hours of delivery.
The freezer should be placed in a warm, dry room, with suitable ventilation.
Allow at least 100mm of space around the unit in all directions.
Never place the freezer in strong sunlight. Place the unit on a level surface making sure that it does not rock.
If the freezer has been stored or transported cold, it must not be started before the compressor is judged to
have reached a temperature at least+5℃. It is recommended to clean up the freezer before starting it.
ELECTRICAL CONNECTION
The freezer must be connected to a socket with the correct voltage/frequency, as show on the nameplate.
The standard for North America is 115V/60HZ. Voltage variations of ±10% are acceptable. Greater
variations can damage the freezer, and in such cases the factory warranty is void.
OPERATING INSTRUCTIONS
The temperature in the freezer is automatically regulated by a pre adjusted thermostat.
The position of the freezer, the ambient temperature, the number of times the lid is opened and for how long
the lid is opened are factors that affect the temperature in the freezer, which should not be placed in sunlight
or positioned close to a heat-radiating surface.
If your freezer is fitted with a lock, the key should be kept out of the reach of children. Remove the lock
mechanism before disposing of any freezers
STORAGE OFF FOOD STUFFS
The freezer must not be filled beyond the height limit of the contents line, or in cases where there is no such
line, to within 100mm below the lid. This is necessary to maintain product temperature of less than+2℃.
DEFROSTING THE CABINET
When the frost layer is 5-8mm thick, the cabinet should be defrosted the following way:
—remove the plug from the socket;
—open the lid and leave it open;
—loosen the frost layer using a plastic or wooden scraper.
Never use sharp or pointed instruments
After final defrosting, the cabinet should be cleaned as described in section: Maintenance. The cabinet
should be thoroughly dried after cleaning.
MAINTENANCE
This freezer can be cleaned using warm water and a mild detergent. Rinse with clean water to finish off.
Never use detergents that contain chlorine.
3
Advertisement
