Advertisement
A breakdown on your Nizo camera is a
very rare thing
.
However, there are certain
minor defects which can be caused
byac-
cidental errors in operation
;
even the most
careful design cannot always avoid
these;
For example, the batteries can give rise to
apparent or genuine
defects.
In such an
event you will be able to trace and rectify
the fault quickly and without outside help
if you follow this trouble-shooting chart.
Minor faults and their remedies
Camera will not start
Possible cause:
Main switch not turned on
Drive batteries defective or exhausted
Oxidation of battery poles
"R" button was not pressed after film
rewind
Automatic single-frame device (filming
speed switch 2) is switched on
Camera starts jerkily
Possible cause:
Drive batteries too weak
Current consumption too high
Possible cause:
Main switch was not turned off during a
prolonged non-filming period
"
Tired" or run -down batteries were
inserted
Remedy:
Here the remedy is obvious
:
switch on!
Check voltage on built-in
meter.
Check that batteries are correctly located
in their box and th
e
right way round
.
Check that battery poles are not dirty.
Clean and polish with a coarse cloth.
If "R" is visible in the indicating window,
the "R" button and the shutter release
must be pressed, to complete the dissolve
cycle.
Set switch to red dot.
Remedy:
Check battery voltage. If too low, replace
enti re set of batteri es.
Remedy:
Only turn on the main switch when about
to use the cam era.
Use only factory-fr esh
batteries.
24
Advertisement
