Advertisement
Quick Links
myTurf™ BaseStation Kit
Wireless Hourmeter System
Model No. 114-5144
Model No. 114-5145
Model No. 115-4754
Model No. 115-9524
Model No. 115-9542
Model No. 115-9543
Electromagnetic Compatibility
Domestic: This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference and (2) this device must accept any interference that may be received, including interference
that may cause undesirable operation.
This equipment generates and uses radio frequency energy and if not installed and used properly, in strict accordance
with the manufacturer's instructions, may cause interference to radio and television reception. It has been type tested and
found to comply within the limits of a FCC Class B computing device in accordance with the specifications in Subpart J
of Part 15 of FCC Rules, as stated above. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient the receiving antenna, relocate the remote control receiver with respect to the radio/TV antenna or
plug the controller into a different outlet so that the controller and radio/TV are on different branch circuits.
If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions.
The user may find the following booklet prepared by the Federal Communications Commission helpful: "How to Identify and Resolve
Radio-TV Interference Problems". This booklet is available from the U.S. Government Printing Office, Washington, DC 20402.
Stock No. 004-000-00345-4.
FCC ID: OF7RTS24
IC: 3575A-RTS24
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Form No. 3415-145 Rev A
Quick Start Guide
Original Instructions (EN)
All Rights Reserved *3415-145* A
Printed in the USA
Advertisement
Related Manuals for Toro myTurf 114-5144
Summary of Contents for Toro myTurf 114-5144
- Page 1 Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. © 2017—The Toro® Company Register at www.Toro.com.
- Page 2 Safety Improperly using or maintaining this system can result in injury. To reduce the potential for injury, comply with these safety instructions and the safety instruction throughout this document, denoted by the safety-alert symbol , which means: Caution, Warning, or Danger—personal safety instruction. Failure to comply with the instruction may result in personal injury or death.
- Page 3 Setup Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty. – No parts required View the myTurf™ BaseStation overview. – No parts required Placing the myTurf™ BaseStation. BaseStation Whip antenna Installing the myTurf™ BaseStation. Power adapter Network cable –...
- Page 4 myTurf™ BaseStation Overview g211216 Figure 1 1. Power 5. myTurf™ connection light 2. Activity light 6. Wireless activity light 3. Connection light 7. Power light 4. Whip antenna 8. Ethernet G011620 g011620 Figure 2...
- Page 5 Placing the myTurf™ BaseStation Choosing a suitable location for the BaseStation has the largest impact on wireless connectivity. You can determine a good location by examining your operating area and equipment movement patterns. Find a place that meets the following requirements: •...
- Page 6 G011626 g011626 Figure 3 g210579 Figure 4...
- Page 7 4. Remove the protective insert from the power adapter and install the plug appropriate for you g211186 Figure 6 region (Figure 1. ID label Plug the power adapter into a power strip, surge protector, or wall outlet. Toro recommends using a surge protector. g211217 Figure 8...
- Page 8 Powering the myTurf™ 3. Ensure that the Internet connection light illuminates (Figure 11). BaseStation The connection LED light flickers and flashes steadily when functioning properly. 1. Plug the power cord into the BaseStation (Figure When the BaseStation has power and is connected to the Internet, the following occurs: •...
- Page 9 If you cannot find the hour meter, consult the Operator’s Manual or log on to www.Toro.com for help locating it. 1. On the new wireless hour meter, record the device ID from the label and machine model and serial number in the space provided on this document.
- Page 10 Adding Wireless Equipment to myTurf™ Log into myTurf.toro.com. Enter your user name and password to access your account. Select the myTurf™ Wireless tab to complete the registration process. Use the training modules on myTurf™ to learn how to register the BaseStation, Repeater (if needed), and wireless hour meters.
- Page 11 Notes:...