Wireless transceiver with gprs connectivity (10 pages)
Summary of Contents for Controlant CO 01.01
Page 1
Controlant provides this document “as is,” without warranty of any kind, expressed or implied, including, but not limited to, the implied warranties of fitness or merchantability for a particular purpose. Controlant may make improvements and/or changes in this manual or in the product(s) and/or the program(s) described in this manual at any time.
Page 2
Contents General Information ............................3 About this guide ............................3 Warranty exception for batteries ........................3 Additional reference material ........................3 Questions and Technical Support ........................3 CO 01.01 Gateway .............................4 Overview................................4 Enclosure ...............................4 Power options..............................4 Power supply .............................4 Battery pack...............................4 LED, Button and Connectors..........................5 Connection and power-on .........................5...
Controlant CO 01.01 Gateway ships with batteries included. Lithium batteries must be replaced by Controlant or service personnel approved by Controlant. No warranty is on the behavior of the CO 01.01 in case of wrong battery installation by non-qualified personnel or in case of usage of batteries which Controlant does not approve of.
Output: 12VDC 2A Battery pack Each CO 01.01 gateway has a built in LiIon battery which will keep the system running in case of external power failure. The battery should only be replaced by Controlant employees or trained personnel approved by Controlant.
ACCORDING TO THE INSTRUCTIONS. LED, Button and Connectors Figure 2: GSM antenna connector, LED, on/Off switch and DC power connector for the CO 01.01 gateway. Connection and power-on 1. Connect the DC plug of the external power supply to the DC power inlet.
The power connector dimensions are 2.5 x 5.5 x 14 mm as shown in Figure 3 and the polarity is shown in Figure 4Figure 3: Mechanical drawings of the DC power plug on the CO 01.01. Figure 3: Mechanical drawings of the DC power plug on the CO 01.01 Figure 4: Polarity of the DC power connector on the CO 01.01...
1.6dBi. Impedance of antenna is 50 Ohm. Figure 5: Antenna pn: ANT-868-CW-QW (with RP-SMA connector). Consult Controlant for use of an alternate, higher gain, antenna. The use of power amplifiers with the RF antenna is prohibited. Specifications and ratings Environmental range 1.
GSM (2G/3G) connectivity. Location of each connector is shown in Figure 6. Antenna connectors are RP-SMA and the GSM antenna connector is SMA. Fuse replacement CO 01.01 Gateways come with an internal fuse. The fuse should only be replaced by Controlant or service personnel approved by Controlant. Wireless Connectivity Controlant wireless devices have up to 300m range in open air.
4. Disturbance on communication frequencies caused by other wireless devices. Wireless range is significantly affected by occluding objects. The indoor range of Controlant devices depends on various factors, including: 1. Building materials in walls and ceilings. 2. Metal objects occluding the path of the signal.
Need help?
Do you have a question about the CO 01.01 and is the answer not in the manual?
Questions and answers