Gigahertz Solutions NFA 30M Operating Manual page 23

The NFA was configurated according to custom-
er requirements with NFAsoft, but when restart-
ing, NFAsoft shows the original settings
The "CONFIG.NFA" file on the SD-card transfers user-
specific configurations to the NFA. NFAsoft can write this
file, but not read it. Therefore you cannot use NFAsoft to
check the configuration of the NFA, but only to install new
You can save configurations as presets to a dropdown
What is the purpose of the individual files and
where are they saved?
"CONFIG.NFA" -> user configurations of the
"NFAsoft.ini" -> Pre-settings for NFAsoft ->
"FIRMWARE.NFA" -> operating system of
There are very many small TXT-files on
the SD-card?
Solution 1: You have activated the function
"permanent logging", which causes the meter
to log not only when switched to "Log". This
option will cause a new file to be started each
time the meter is switched on, and each time
Solution 2: There is a file system error on your
SD-card. In this case, save the "good" files and
re-format your SD-card using the original SD-
formatter of the SD Association (to be found
https://www.sdcard.org/downloads/index.html)
© Gigahertz Solutions GmbH
same folder as NFAsoft
the NFA -> SD-card
you switch from one mode to the other.
under the following link:
- 21 -
Made in Germany
ones.
menu in NFAsoft.
NFA-> SD-card
.
January 2018