Advertisement
Installation
Transmitter batteries replacement/installation
1) Slide the battery cover in the direction as shown to remove the cover.
2) Install 8pcs alkaline or rechargeable "AA" size cells into the battery holder that connected with the transmitter.
3) Slide on the battery cover and make sure it is closed securely.
4) Turn the power on to check. If the Power Indicator LED fails to light, check the batteries for insufficient contact
or incorrect battery polarity.
While pressing
this part
Battery cover
NOTE:
a) Use only fresh, alkaline cells, all of the same brand.
b) Make certain that the contacts in the battery hold er stay clean by using a pencil eraser to gently remove any
corrosion or dirt that may accumulate on them. It is recommended to do this each time you install fresh cells
into your transmitter.
c) If use the rechargeable 9.6V battery pack, then just remove the battery holder by pull out the connector from
the transmitter. Then plug-in the battery pack connector to the transmitter.
d) When the rechargeable battery is installed in the transmitter, they can be charged through the external charging
jack located on the transmitter.
WARNING:
a) Do not attempt to charge the alkaline batteries, they may cause explode!!
b) When charge the rechargeable battery, set the power switch on "OFF" position before charging. And the
charger plug must be correct type ("+" inside and "-"outside, type TAMIYA N-3U or equivalent). The wrong
type may burst causing personal injury and damage.
c) Always be sure the batteries are loaded in the correct polarity order. If the batteries are load incorrectly, the
transmitter may be damaged.
Receiver battery replacement/installation
Insert 4 fresh AA cells into the receiver battery holder. Make sure the batteries are located in the correct polarity
order. Maintain the battery contacts in the same way as described in previous section.
Insert the switch harness plug into the receiver socket marked "BATT".
Battery cell (x8)
Advertisement
