Related Manuals for Ace Cougar P3i
Summary of Contents for Ace Cougar P3i
- Page 1 Digital Pistol Grip Radio Control System No.8306 Please read all instructions thoroughly before assembling the kit. The contents are subject to change without prior notice due to product improvements and specification changes.
- Page 2 Introduction Congratulations on your purchase of an ACE Cougar P3i digital proportional radio system. The Cougar P3i is the best choice of the computer pistol grip radio system for driver requirement precision and smoothness of operation at the same time. Equipped with the 10-model memory, large LCD display, digital trims, AUX channel 3 button, and lots of advanced programming functions with all of the new bells and whistles.
- Page 3 System contents Item COUGAR P3i Radio System Item No 8306 8306-S1 8306-C1 Transmitter COUGAR P3i Receiver TR301F Servos S1903 x 1 C1016 x 1 Accessory Switch hardness x 1, Receiver Battery holder x 1, Frequency flag x 1 Specifications Transmitter...
- Page 4 Transmitter Antenna Digital Throttle Trim lever Steering Wheel Power Indicator Digital Steering D/R(Dual Rate) lever Power Switch Edit Buttons AUX Ch Button Throttle Trigger LCD Display External Charging Jack Steering tension adjustment Digital Steering Trim lever RF Module and crystal Battery Cover...
- Page 5 NOTE: It’s recommended to use only the ACE crystal set, and to change the both transmitter and receiver crystal at the same time.
- Page 6 Installation Transmitter batteries replacement/installation 1) Slide the battery cover in the direction as shown to remove the cover. 2) Install 8pcs alkaline or rechargeable “AA” size cells into the battery holder that connected with the transmitter. 3) Slide on the battery cover and make sure it is closed securely. 4) Turn the power on to check.
-
Page 7: Radio Installation
Radio installation 1) Connect the receiver, servos, and switch hardness/battery pack as shown. 2) If you are not familiar with all the control system. Do the “bench test” before to install all the devices on the model. 3) A build-in BEC (Battery Eliminator Circuitry) function are adopted in the receiver. 4) Always follow the “transmitter on first, off last”... - Page 8 1) For the current battery status can be easy read from the voltage value or battery status diagram. Charging or change the battery when the voltage is lower than 8.8V. 2) For the radio RF system, the Cougar P3i is adopt the PPM system, so the . will be show on the display all the time.