Subscribe to Our Youtube Channel
Related Manuals for Agrident AIR200
Summary of Contents for Agrident AIR200
- Page 1 Agrident GmbH, Steinklippenstr. 10, D-30890 Barsinghausen Phone +49 5105 520614 - Fax +49 5105 520616 AIR200 Installation V10/07/06...
- Page 2 Agrident GmbH. Agrident reserves the right to make changes to any and all parts of this documentation without obligation to notify any person or entity of such changes.
- Page 3 Installation Contents Introduction......................4 Specification ......................4 Installation ......................4 Installation of the AIR200 reader ..............4 Installation of the AEA080 antenna .............. 8 Safety and care ....................9 Warranty......................9 FCC digital device limitations ................10 CANADIAN RADIO EMISSIONS REQUIREMENTS ......... 10 CE MARKING....................
- Page 4 AIR200 Installation 1. Introduction The ISO reader module AIR200 is designed as an integrated reader head for the handheld computer Workabout PRO M/C by PSION TEKLOGIX. It combines the reading of ISO ® transponders with the Windows CE software of the PSION -workabout PRO.
- Page 5 AIR200 Installation Pull out the 4 screws on top and the 6 screws on the back. Push the SW1401 switch in position OFF. Remove the cover from the battery room by unlocking the screws. Remove the battery. Put in the adapter board as shown above.
- Page 6 AIR200 Installation Fix the adapter board with the 4 added screws. Push the SW1401 switch in position ON, again. Now stick the AIR 200 reader to the Workabout and fix it with the 2 added washers and PRO, as shown screws.
- Page 7 AIR200 Installation Put in the battery and close the battery room by bolting the cover with the screws. Push the pen back in its holder. Keep the Workabout's head cover, in case that you might need it. Please follow the instructions of the protocol, before you start a read.
- Page 8 Binder plug. Put the Binder plug of the stick antenna in the Pay attention to the groove. socket of the AIR200 reader. Follow the instructions of your Workabout PRO, to start a read.
- Page 9 This exclusion of liability does not apply to claims made on the basis of the Product Liability Act. c. Warranty claims cannot be entertained unless the Agrident system was installed properly and used properly and for the purpose intended.
- Page 10 8. CE MARKING Hereby, Agrident BV declares that this equipment, if used according to the instructions, is in compliance with the essential requirements and other relevant provisions of the RTTE Directive 1999/5/EC. For use in all countries of the EU.
- Page 11 AIR200 Installation To obtain a copy, contact Agrident BV and request the “Declaration of Conformity” document for Multi-technology readers. Agrident BV mail@agrident.com In case of alteration of the product, not agreed to by us, this declaration will lose its validity.
Need help?
Do you have a question about the AIR200 and is the answer not in the manual?
Questions and answers