Using The Self-Propel Drive - Toro 20797 Operator's Manual

Using the Self-Propel Drive

To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the machine will automatically keep pace
with you (Figure 19).
Figure 19
Note:
If the machine does not freely roll backward
after self-propelling, stop walking, hold your hands
in place, and allow the machine to roll a couple of
centimeters (inches) forward to disengage the wheel
drive. You can also try reaching just under the upper
handle to the metal handle and pushing the machine
forward a couple of centimeters (inches). If the
machine still does not roll backward easily, contact an
Authorized Service Dealer.
Shutting Off the Engine
Service Interval: Before each use or daily
To shut off the engine, release the blade-control bar.
Note:
Remove the electric-start button (if equipped)
whenever you leave the machine.
Important:
When you release the blade-control
bar, the engine should shut off and the blade
should stop within 3 seconds. If they do not, stop
using your machine immediately and contact an
Authorized Service Dealer.
Recycling the Clippings
Your machine comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
If the side-discharge chute is on the machine, remove
it and lock the side-discharge door; refer to
the Side-Discharge Chute (page 18)
the clippings.
Important:
Ensure that the rear plug is locked in
place. To lock the plug, raise the rear door
20), firmly push the plug in until it snaps into place
behind the tabs, and rotate the lever on the plug
to the left (Figure 21).
1. Rear door
g003221
Removing
before recycling
1. Lever
(Figure
Note:
plug to the right
15
Figure 20
2. Rear plug
Figure 21
2. Tabs
To unlock the rear plug, rotate the lever on the
(Figure 21).
g017463
g010084