Replacing The Fuse - Toro 20372 Operator's Manual

•
A green light indicates that the charger is fully
charged or the charger is disconnected from the
battery.
•
A flashing light that alternates between red and
green indicates that the battery is nearly fully
charged. This state lasts only a few minutes until
the battery is fully charged.

Replacing the Fuse

Electric-Start Model Only
If the battery does not charge or the engine does not
run with the electric starter, the fuse may be blown.
Replace it with a 40 A plug-in type fuse.
1. Refer to Preparing for Maintenance (page
2. Raise the rear deflector and locate the battery
compartment (Figure
Note:
There is an adhesive-backed covering
that protects the battery compartment.
1. Rear deflector
2. Screw
3. Wipe away any debris in the battery compartment
area and remove the adhesive-backed covering.
4. Remove the screw that secures the battery
compartment, pull out the battery, and locate the
fuse (Figure 31 and
31).
Figure 31
3. Battery
4. Battery compartment
Figure 32).
20).
1. Battery cover
2. Fuse
5. Replace the fuse in the fuse holder
Note:
attached to the battery-charger box (Figure 37).
g009506
1. Battery compartment
6. Install the battery compartment with the screw
that you removed in step 4.
7. Install the covering over the battery
compartment.
8. Lower the rear deflector.
23
Figure 32
3. Fuse holder
Your machine comes with a spare fuse
Figure 33
2. Battery-charger box
g030022
(Figure 32).
g030053