Initstrings - Andrew Node C837 User Manual

Check the communication mode between the modem and the terminal. The
following parameters should be set for a GSM modem.
Bit rate / bit per second:
Parity bit:
These settings may only be changed locally. Should a different modem be used, the
operator should ensure that the settings are changed prior to leaving the site.
5.4.1.1

Initstrings

The initialization string depends on the operator's network and the modem. It may be
necessary to adjust the init string in the field. The following init string is factory set.
Modem Network
not yet available
via Node C Web Interface: t.b.d.
5.4.1.2 Wireless Modem
The wireless modem allows remote
control and maintenance of the Node C.
Parameters may be changed; alarm and
measurement statistics
acknowledged and collected in the
OMC.
The modem is installed in the cover of
the Interface Unit.
connector for the modem is located at
the connector panel of the Interface Unit
For technical data of the modem refer to
chapter 7.2.3 Specifications for Optional
Equipment.
Page 84
User's Manual for Node C Network Elements
9600 baud
No parity
t.b.d.
table 5-2 Standard initstring for modem
may be
The antenna
PRELIMINARY
Number of data bit:
Stop bit:
Initstring
8 bit
1 stop bit
M0121A1A_uc.doc