Figure 3-6 Back-To-Back Pole Mounting - Andrew Node C837 User Manual

Both types of pole mounting kit consist of the following parts (in different quantities):
No Part
1 Pole mounting brace
2 Washer DIN 9021 – 8.4
3 Nut M8 DIN 934
4 Spring ring DIN 127 – A8
The numbers in the above table refer to the numbering of the components in the
following figures. Positions 7 and 8 are only required for mounting two systems.
• Dismount the mounting brackets from the cabinets of the units by loosening the
hexagon head screws M10x20 by which the brackets are screwed to the housing
(four per unit). Do not unscrew those screws, only loosen them by approx. three
turns and take off the brackets.
• Fasten the mounting brackets to the pole using the corresponding mounting kit as
illustrated in figure 3-7 Pole mounting two systems or figure 3-6 Back-to-back pole
mounting, respectively.
Page 18
table 3-3 Components of pole mounting kits

figure 3-6 Back-to-back pole mounting

PRELIMINARY
User's Manual for Node C Network Elements
No Part
5 Thread-bolt M8
6 Washer M8 DIN 125
7 Hexagon head screw M8
8 Fastener
M0121A1A_uc.doc