Subscribe to Our Youtube Channel
Related Manuals for A.J.Antunes UF-216C Series
Summary of Contents for A.J.Antunes UF-216C Series
- Page 1 MANUFACTURING NUMBERS: 9700405 WATER FILTRATION SYSTEM UF-216C Series P/N 1010885 07/04 Owner s Manual ’...
- Page 2 UF-216 WATER FILTRATION SYSTEM TABLE OF CONTENTS Owner Information .............2 Operation..............13 General..............2 Filtration Process............ 13 Warranty Information ..........2 LED Display ............13 Important Safety Information ........3 Starting the System ..........13 Service/Technical Assistance ........3 Programming Timer ..........13 Specifications .............5 Setting the Flush Interval (Fi) .........
-
Page 3: Important Safety Information
UF-216 WATER FILTRATION SYSTEM OWNER INFORMATION (continued) Service/Technical Assistance Purchased From: If you experience any problems with the installation Date of Purchase: or operation of your unit, contact Antunes Equipment Model No.: Manufacturing (Suzhou) Co., Ltd. at 86-512-684-3637. Serial No.: Fill in the information in the next column and have it handy when calling for assistance. - Page 4 UF-216 WATER FILTRATION SYSTEM IMPORTANT SAFETY INFORMATION (continued) • Keep cord away from heated surfaces. installed by a qualified electrician. The following warnings and cautions appear throughout - Do not use an extension cord with this appli- this manual and should be carefully observed. ance.
-
Page 5: Specifications
UF-216 WATER FILTRATION SYSTEM SPECIFICATIONS Electrical Ratings Specifications (Filter Cartridges) Voltage Watts Hertz Maximum Operating Pressure 7 bar (100 psi) 50/60 Maximum Operating Temp. 40°C (104°F) Trans Membrane Pressure 0.5-2.5 Bar (7-36 psi) pH Range 3-10 Electrical Cord & Plug Configurations MWCO 100 kD Letter... -
Page 6: Components
UF-216 WATER FILTRATION SYSTEM SPECIFICATIONS (continued) Components Permeate Nipple Inlet Nipple Figure 2a. Components P/N 1010885 07/04... -
Page 7: Components
UF-216 WATER FILTRATION SYSTEM SPECIFICATIONS (continued) Components Drain Permeate LED Display Program Button Power Cord Filter Cartridge Strainer Inlet Figure 2b. Components P/N 1010885 07/04... -
Page 8: Unpacking
UF-216 WATER FILTRATION SYSTEM INSTALLATION Do not over tighten the connections. It is recommend- Unpacking ed that plastic fittings be used when connecting to the 1. Remove the system and all packing materials plastic connections of the system. This will reduce the from the chipping carton. -
Page 9: Locating And Mounting The System
UF-216 WATER FILTRATION SYSTEM INSTALLATION (continued) Locating and Mounting the system The drain line is used to flush away the particle buildup when cleaning the filter. The drain line must be able Consider these points before mounting the system: to support the flow rate when the system flushes. The flow rate from the flush depends on the inlet water pres- •... -
Page 10: The Unit
UF-216 WATER FILTRATION SYSTEM INSTALLATION (continued) Drain Line Secure from System Drain Line from System 2” minimum Standpipe Secure 2” minimum Floor Drain Drain Figure 3. Proper Draining 30 seconds to keep the drain open. This flushes CAUTION air out of the center of the hollow fibers. The Ingesting the protective solution may cause irrita- drain will remain open as long as the Start button tion of the gastrointestinal tract, colic, diarrhea, or... - Page 11 UF-216 WATER FILTRATION SYSTEM INSTALLATION (continued) Refer to the figure to the right and follow the Steps below to install and flush the Carbon Cartridge. 1. Shut off the water to the system using the inlet water valve. 2. Open the tap or faucet closest downstream to the Filter Housing filter system to relieve pressure in the system.
-
Page 12: General
UF-216 WATER FILTRATION SYSTEM INSTALLATION (continued) The plumbing must be sanitized to eliminate possible 5. When the water flow out of the strainer stops, contamination that may have occurred during the instal- pour the liquid bleach into the strainer. Be care- lation process. -
Page 13: Operation
UF-216 WATER FILTRATION SYSTEM OPERATION Starting the System Filtration Process Power up the unit. Water filtration in the UF-216 is accomplished using two modes: Flush Interval Mode, shown as Fi on the The LED read-out displays the following for about two LED Display and Flush Duration Mode (Fd on LED dis- seconds each: play). -
Page 14: Setting Flush Duration (Fd)
UF-216 WATER FILTRATION SYSTEM OPERATION (continued) Setting Flush Duration (Fd) 2. When Fd is displayed, press and release start but- ton to view current setting (Figure 7). 3. To make a change, press and hold down start button to scroll through settings - release button at desired setting (Figure 8). -
Page 15: Programming Timer While Unit Is In Flush Interval (Fi) Mode
UF-216 WATER FILTRATION SYSTEM OPERATION (continued) Programming continued Programming Timer While Unit is in Flush Interval (Fi) Mode TO SET Fi - FLUSH INTERVAL MODE NOTE: After power-up and cycling - Fi time setting displays a flashing decimal point. 1. Press and hold down start button for four seconds. -
Page 16: Manual Flushing
UF-216 WATER FILTRATION SYSTEM OPERATION (continued) Manual Flushing NOTE: Manual flushing only works when unit is in Flush Interval Mode (Fi). While the unit is in Flush Interval Mode (decimal point flashing), hold the start button down for 6-7 seconds until the LED displays FL (Figure 11). Continue holding the button down to keep the drain open. -
Page 17: Changing The Cartridges
UF-216 WATER FILTRATION SYSTEM MAINTENANCE 2. Place a bucket under the strainer at the inlet The filtration system is designed to require very little connection to the system. Open the strainer by maintenance. To ensure that the water is of the highest unscrewing the cap. -
Page 18: Troubleshooting
UF-216 WATER FILTRATION SYSTEM TROUBLESHOOTING Problem Possible Cause Corrective Action Unit does not have power. The power cord is not correctly Plug power cord in correctly. plugged in. The Control Display is blank. The power cord is not correctly Plug power cord in correctly. plugged in. -
Page 19: Replacement Parts Uf-216
UF-216 WATER FILTRATION SYSTEM REPLACEMENT PARTS UF-216 � � � �� �� � � �� � � �� � � � � P/N 1010885 07/04... - Page 20 UF-216 WATER FILTRATION SYSTEM REPLACEMENT PARTS UF-216 (continued) Item Part Description Qty. Item Part Description Qty. SLTRSHD 3100183 Screw, TAP #10-24 x 3/4” 1001083 Label, Drain PHPANHD T-F T/C 0504251 Shroud 0504250 Back Plate 0200246 O-Ring, Filter Housing Sump 2190149 Nipple, 4”...
- Page 21 UF-216 WATER FILTRATION SYSTEM REPLACEMENT PARTS UF-216 (continued) �� �� �� �� � �� �� �� �� �� �� �� �� �� � �� �� �� �� �� � �� � � � �� � � �� �� �� � ��...
- Page 22 UF-216 WATER FILTRATION SYSTEM REPLACEMENT PARTS UF-216 (continued) Item Part Description Qty. Item Part Description Qty. 7000433 Timer, 230V 2180177 Cap, End 2” 1001116 Label, Timer 0200219 “O” Ring 2” 0700354 Power Cord 2190133 Tee Strainer 1/2” NPT 040K251 Strain Relief, Power Cord 2090129 Screen, Tee Strainer 1/2”...
-
Page 23: Wiring Diagram
UF-216 WATER FILTRATION SYSTEM WIRING DIAGRAM POWER CORD NOTE: ALL WIRED TO BE 16 GA.. AWM-105ºC UNLESS OTHERWISE SPECIFIED 14 GA. AWM - 105ºC 22 GA. AWM - 105ºC TERMINAL BLOCK TIMER BOARD SOLENOID VALVE P/N 1010885 07/04... - Page 24 LIMITED WARRANTY Equipment manufactured by Antunes Filtration Technologies, Division of A.J. Antunes & Co. has been constructed of the finest materials available and manufactured to high quality standards. These units are warranted to be free from mechanical and electrical defects for a period of one year from date of purchase or 18 months from shipment from fac- tory, whichever occurs first, under normal use and service, and when installed in accordance with manufacturer’s recom- mendations.
Need help?
Do you have a question about the UF-216C Series and is the answer not in the manual?
Questions and answers