Flurida FDFB10501 Installation Instructions

WATER FILTER INSTALLATION INSTRUCTIONS
FDFB10501 & FDFT10501 Water & Ice Dispenser
Water line installation
A municipal water supply or other potable water with water pressure
NOTE
between 15 and 120 psig is required to operate this unit. Drain is not
required.
1. Unplug the unit.
2. Prepare a water supply line using ¼" OD tubing (A) with a compression
nut (B) and sleeves (C) on one end. Connect the tubing to the shutoff
valve by screwing the compression nut.
3. Place the free end of the tubing in a container or sink and turn the
shutoff valve on to flush the tubing until water is clear. Then turn the
shutoff valve off.
4. Remove the plug of the water line connector (8), which is located at the
back of the unit. Insert the free end of the tubing into the water line
connector (8).
!
!
Water filter installation
1. Open the storage door more than 90 degrees.
2. Check if the pump pipe connector (1) is closed with a plug.
3. Remove the plugs of the water inlet (2) and outlet (3) inside the storage.
w w w . f l u r i d a . c o m
! 1