Advertisement
Quick Links
Advertisement
Related Manuals for JAPAN UNIX UNI-SENSOR 701A
Summary of Contents for JAPAN UNIX UNI-SENSOR 701A
- Page 1 Digital Thermometer UNI-SENSOR 701A Operating Instructions Ver. 2.0...
- Page 2 UNI-SENSOR 701A Operating Instructions Table of Contents Introduction.......................1 Precautions....................1 Features ....................2 Checking the Thermometer ..............2 Specifications....................2 How to Operate the Thermometer and Descriptions of the Functions ..3 How to Use Each Sensor (Optional) ............7 Sensor Group for Various Applications .............8...
- Page 3 1. Precautions Before using the UNI-SENSOR 701A digital thermometer, be sure to read the following cautions and understand them well. Use the UNI-SENSOR 701A digital thermometer under the environment that is regulated with the specifications only.
-
Page 4: Specifications
3. Checking the Thermometer Take out the UNI-SENSOR 701A from the package at first. Check the supplied parts one by one from the following figure to see if you have all parts and if any of them is not damaged. If you do not have any of them or if any of them is damaged, contact the dealer from which you have purchased the thermometer. - Page 5 5. How to Operate the Thermometer and the Descriptions of the Functions 5.1 How to insert a battery • Open the battery lid. • Connect the power cable to the battery. • Insert the battery. • Close the battery lid. If you do not use the thermometer for a long time, the battery may leak.
- Page 6 5.3 How to measure the temperature of an iron tip • Melt wire solder with the iron tip, and put the iron tip to the center of the sensor to measure its temperature. It takes a while for the temperature to CAUTION become stable after solder is melted.
- Page 7 5.5 Various HOLD functions HOLD function The current measured temperature data is held and displayed. “HOLD” lights on the display. Selection (Maximum value HOLD function) The maximum Maximum value HOLD function (MAX/HOLD) Maximum temperature display mode temperature is displayed. When “MAX” and “HOLD” are lighting on the display, the A normal measurement value is displayed.
-
Page 8: Error Messages
5.6 Error messages (1) Indication of the broken sensing edge If the sensing edge of the probe is broken or if the probe is not connected to the thermometer, “Err” appears on the display as shown in the right figure. If this message appears on the display, replace the probe with a new one or connect the probe to the thermometer. - Page 9 6. How to Use Each Sensor (Option) ① How to put the surface sensor to the target Put the surface sensor to the contact surface of the target vertically. Note that the thermometer cannot detect the correct temperature if the contact surface of the target is not smooth or flat.
- Page 10 7. Sensor Group for Various Applications Model name Shape Tip of the Operating Feature/Application sensor temperature • You can measure the UNI-9 temperature of an iron tip Sensor for an iron tip Normal correctly. (Supplied with the temperature to + 500°C thermometer)）...
- Page 11 8. Maintenance About storage When you store the thermometer, avoid places (environment) subjected to: • Direct sunlight • High temperature • High humidity • Vibration ♦ The case of the thermometer is made of ABS resin. Be careful not to bring it close a substance whose temperature is very high so that it cannot be deformed.
- Page 12 HEAD OFFICE 21-25, Akasaka 2-Chome, Minato-ku, Tokyo 107-0052, Japan URL http://www.japanunix.co.jp.