Aerodr Portable Rf Unit - Konica Minolta AeroDR Portable UF Unit Operation Manual

6 .1 Maintenance and inspection items
This chapter describes the inspections and cleaning
required in order to maintain the use of the AeroDR
Portable RF Unit in an optimum condition .
6 .1 .1 Maintenance schedule
The maintenance and inspection items that the user
should perform are as follows .
Maintenance task
Checking and cleaning the surface of the

AeroDR Portable RF Unit

Checking for external damage to the AeroDR
Portable RF Unit
Full charge of the AeroDR Portable Unit Battery
IMPORTANT •••••••••••••••••••••••••••••••••••••
• To ensure optimum use of the AeroDR Portable RF
Unit, be sure to perform periodic maintenance .
• The above task intervals are estimates and vary ac-
cording to usage .
• • •• • • •• • • •• •••••••••••••••••••••••••••••••••• •••••••
6 .1 .2 Cleaning
The cleaning method for each device is as follows .
z AeroDR Portable RF Unit
• Clean dust on the insert table of the AeroDR Portable
RF Unit with a soft cloth moistened with anhydrous al-
cohol or water .
Power LED light
z Mount kit
• Clean dust on the mount kit with a soft cloth moistened
Mainte-
nance
interval
Weekly
Weekly
Monthly
The approximate battery replacement cycle is follows .
AeroDR Portable Unit Battery
LAN port
56
IMPORTANT •••••••••••••••••••••••••••••••••• • ••
• Be careful not to apply any cleaning chemical or liquid
onto the Power LED and LAN port .
• Do not clean with sharp or hard metal objects . If you
cannot remove stains, contact Konica Minolta techni-
cal representatives .
•••••••••••••••••••••••••••••••••••••••••••••••••• • ••
with anhydrous alcohol or water .
IMPORTANT •••••••••••••••••••••••••••••••••• • ••
• Do not use bleaching agents .
•••••••••••••••••••••••••••••••••••••••••••••••••• • ••
6 .1 .3 Periodical replacement
parts
Replacement parts
IMPORTANT •••••••••••••••••••••••••••••••••• • ••
• The replacement cycle depends on the frequency of
battery operation and conditions .
• Refer to each device's manual for information about
periodic replacement parts and consumables for the
image processing controller, battery for 17-inch moni-
tor, UPS, etc .
• In particular, continued use of the battery may result
in degradation and wear, and it may no longer exhibit
proper functioning capabilities . For extended, safe
use, it is necessary to replace parts which have be-
come worn or degraded .
•••••••••••••••••••••••••••••••••••••••••••••••••• • ••
Estimated
replacement
2 years