Table of Contents
Advertisement
This appliance may be installed in an aftermar-
ket permanently located, manufactured home
(USA only) or mobile home, where not prohib-
ited by local codes. This appliance is only for use
with the type of gas indicated on the rating plate.
This appliance is not convertible for use with other
gases, unless a certified kit is used.
RETAIN THESE INSTRUCTIONS
FOR FUTURE REFERENCE
WARNING: IF THE INFORMATION IN THIS MANUAL
IS NOT FOLLOWED EXACTLY, A FIRE OR EXPLO-
SION MAY RESULT CAUSING PROPERTY DAM-
AGE, PERSONAL INJURY OR LOSS OF LIFE.
FOR YOUR SAFETY: Do not store or use gasoline
or other flammable vapors or liquids in the vicin-
ity of this or any other appliance.
FOR YOUR SAFETY: What to do if you smell gas:
• DO NOT light any appliance.
• DO NOT touch any electrical switches.
• DO NOT use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone.
Follow your gas suppliers instructions.
• If your gas supplier cannot be reached, call the
fire department.
Installation and service must be performed by a
qualified installer, service agency or the gas
supplier.
OTL Report No. 116-F-18-05
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
INSTALLATION
INSTRUCTIONS
B-VENT ELITE
B-VENTED GAS APPLIANCES
P/N 504,137M REV. L 03/2007
MODELS
Millivolt Models
LBV-3824MN
LBV-3824MP
LBV-3824MN-H
LBV-3824MP-H
LBV-4324MN
LBV-4324MP
LBV-4324MN-H
LBV-4324MP-H
AVERTISSEMENT: ASSUREZ-VOUS DE BIEN SUIVRE
LES INSTRUCTIONS DONNÉ DANS CETTE NOTICE POUR
RÉDUIRE AU MINIMUM LE RISQUE D'INCENDIE OU
POUR ÉVITER TOUT DOMMAGE MATÉRIEL, TOUTE
BLESSURE OU LA MORT.
POUR VOTRE SÉCURITÉ: Ne pas entreposer ni utiliser
d'essence ni d'autre vaperurs ou liquides inflammables
dans le voisinage de cet appareil ou de tout autre
appareil.
POUR VOTRE SÉCURITÉ: Que faire si vous sentez une
odeur de gaz:
• Ne pas tenter d'allumer d'appareil.
• Ne touchez à aucun interrupteur. Ne pas vous servir
des téléphones se trouvant dans le batiment où
vous vous trouvez.
• Evacuez la piéce, le bâtiment ou la zone.
• Appeflez immédiatement votre fournisseur de gaz
depuis un voisin. Suivez les instructions du
fournisseur.
• Si vous ne pouvez rejoindre le fournisseur de gaz,
appelez le service dos incendies.
L'installation et service doit être exécuté par un qualifié
installer, agence de service ou le fournisseur de gaz.
®
SERIES
Electronic Models
LBV-3824EN
LBV-3824EP
LBV-3824EN-H
LBV-3824EP-H
LBV-4324EN
LBV-4324EP
LBV-4324EN-H
LBV-4324EP-H
1
Advertisement
Table of Contents
Related Manuals for Lennox Hearth Products LBV-3824MN
Summary of Contents for Lennox Hearth Products LBV-3824MN
- Page 1 (USA only) or mobile home, where not prohib- Millivolt Models Electronic Models ited by local codes. This appliance is only for use LBV-3824MN LBV-3824EN with the type of gas indicated on the rating plate. LBV-3824MP LBV-3824EP...
- Page 2 PACKAGING GENERAL INFORMATION TABLE OF CONTENTS Note: Installation and repair should be per- Packaging ........page The assembled vented gas fireplace is pack- formed by a qualified service person. The appli- aged with: Introduction ........page ance should be inspected annually by a quali- fied professional service technician.
-
Page 3: Location
This appliance may be installed in an after- Do not place clothing or other materials on or AVERTISSEMENT: SURVEILLER LES market permanently located, manufactured near this appliance. ENFANTS. GARDER LES VÊTEMENTS, home (USA only) or mobile home, where not LES MEUBLES, L'ESSENCE OU AUTRES prohibited by local codes. -
Page 4: Appliance Specifications
CLEARANCES APPLIANCE SPECIFICATIONS Minimum clearance to combustibles for the ap- 12 ⁷⁄₁₆" pliance is as follows: sides and back - ¹⁄₂" (13 mm), floor - 0" (0 mm), adjacent wall - 0" (0 mm), ceiling - 37 ¹⁄₂" (953 mm). 11 ¹⁄₂"... -
Page 5: Framing Specifications
FRAMING SPECIFICATIONS ASSEMBLY STEPS Back Wall of Chase/Enclosure Including Finishing Materials The typical sequence of installation follows, FOAK-4 if any Combustion however, each installation is unique resulting Air Kit in variations to those described. 1. Construct the appliance framing. 2. Route gas supply line to appliance location. 3. - Page 6 4. Use this information and consult your local An external regulator must be used on all IMPORTANT: UNDER NO CIRCUMSTANCES building code to determine if you need addi- propane (L.P.G.) heaters to reduce the supply CAN THE FIREPLACE TOP SPACERS (refer to tank pressure to 13"...
-
Page 7: Installation
Step 4. Install the Vent System & Exterior Termination - A - Connect the factory-supplied B-Vent con- nector (found taped to the top of the unit) as shown in Figure 11 . Press it into the lanced 45 degrees max. protrusions internal to the flue outlet collar as far as the horizontal rolled seam located on the lower part of the connector, and secure with... -
Page 8: Connecting Gas Line
The gas control valve is located in the lower C. When the gas lines are tested and leak free, Electronic Wiring Diagram (Honeywell) control compartment. To access the valve be sure to rinse off the leak testing solution. (Optional ON/OFF Switch Wiring) remove the refractory access panel and set 1. - Page 9 Note: Supply wires may be alternatively connected to the outlet using the screw terminals, however CAUTION: NEVER LOCATE INLET WHERE IT the black supply wire must be wired to a terminal that is opposite (across the outlet) the point where CAN BE BLOCKED BY SHRUBS, SNOW the white supply wire is connected.
-
Page 10: Appliance Operation
Subsequent lightings of the appliance will not require such purging. Inspect the pilot flame (remove logs, if necessary, handling carefully). Typical Log Set MANUALLY-RESET BLOCKED FLUE SAFETY (Refer to Owners SWITCH Manual for Details) SIT Valve Piezo Ignitor This appliance is equipped with a manually- reset blocked flue safety switch. -
Page 11: Millivolt Appliance Checkout
Millivolt Appliance Checkout Step 10. Adjustments – The following para- Adjustment graphs address adjustment concerns and pro- The pilot flame should be steady, not lifting or cedures. To adjust the flame, position the air shutter to floating. Flame should be blue in color with the nominal setting (Figure 24 ). -
Page 12: Finishing Requirements
INSTALLATION ACCESSORIES Finished The following accessory items are available for Wall use in the installation of this appliance. Outside Air Kits Models FOAK-4 and FOAK-4LD Header 12" Max. Outside Air kits are available with duct Spacer Combustible Mantel (FOAK-4) and without duct (FOAK-4LD) and Trim for use if outside combustion air is re- Non-combustible... -
Page 13: Gas Conversion Kits
Gas Conversion Kits WARNING: THIS CONVERSION KIT SHALL BE IN- AVERTISSEMENT: CET ÉQUIPEMENT DE CONVERSION STALLED BY A QUALIFIED SERVICE AGENCY IN AC- SERA INSTALLÉ PAR UNE AGENCE QUALIFIÉE DE SERVICE CORDANCE WITH THE MANUFACTURER'S INSTRUC- CONFORMÉMENT AUX INSTRUCTIONS DU FABRICANT ET TIONS AND ALL APPLICABLE CODES AND REQUIRE- TOUTES EXIGENCES ET CODES APPLICABLES DE MENTS OF THE AUTHORIZED AGENCY HAVING JU-... - Page 14 Step 5. Honeywell Systems - See Figure 28 Step 1. Turn off the gas supply to the appli- and the instructions provided with the kit. Re- ance. Remove the front glass door (if used) move the black thread-protecting cap. Remove from the appliance.
- Page 15 All Models Step 9. Unscrew the orifice from the manifold and replace it with the one provided with the Pilot Assembly kit . See the following table for orifice sizes for natural and propane models. Figure 32 illus- trates the orifice. Orifice Size Ignitor Series...
- Page 16 Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. Printed in U.S.A. © 2001 by Lennox Hearth Products P/N 504,137M REV.