Advertisement
2. Thread a nylon cable tie through each of the
holes on the sensor. Loop cable tie around the
crank arm then thread the end through the
opening and past the ratchet. Pull to secure
into place.
3. Using the alignment notch as a guide, position
sensor on any bar which is along the magnet's
path.
4. With the battery compartment facing the
magnet, thread a nylon cable tie through each
hole on the sensor. Loop cable tie around the
bar then thread the end through the opening
and past the ratchet. Pull to secure into place.
NOTE Improper alignment may affects sensor's
performance.
TIP Cut away unnecessary cable tie to avoid it
being caught in the wheel while in motion.
PAIRING DEVICE
The AD202 can be paired with your heart rate
monitor (watch) or sports accessory to provide
speed / cadence readings. The bike pod has a
maximum transmission range of about 62.5
centimeters (25 inches).
To pair with Oregon Scientific heart rate monitors
that use the 2.4GHz ANT+ Sports System, please
refer to below pairing instructions.
To pair with sports accessories or heart rate
monitors of another make, please refer to
manufacturer's instructions.
PAIR WITH OREGON SCIENTIFIC SPORTS
ACCESSORIES / HEART RATE MONITORS
NOTE While pairing, make sure to stay away from
other devices and move the device to pair close to
the watch.
1. Press MODE repeatedly to select
watch will show how many and which devices
are paired (if any). If no device is paired, the
watch will show "0 DEVICE PAIRED".
2. Press SET to enter "PAIR DEVICE?". Press
SET to start pairing.
When the bike pod is paired successfully, the watch
will display
NOTE If pairing is weak and unstable:
•
Shorten the distance between the device and
watch.
•
Re-adjust the position of the device.
•
Check the batteries. Replace them when
necessary.
If the watch is already paired with a bike pod, you
have to first delete the bike pod before you are able
to pair with another bike pod.
INPUT BIKE WHEEL SIZE
NOTE The watch will not show "WHEEL SIZE" if no
bike pod is paired.
If your watch is paired with bike pod, the watch will
prompt you to input the wheel size values. Go
directly to step 5.
For normal setting procedure, start with step 1.
1. Press MODE repeatedly to select
2. Press SET.
. The
.
Advertisement
