1. Manuals
  2. Brands
  3. Green Point Manuals
  4. Accessories
  5. igh
  6. User manual

Green Point igh User Manual

Hide thumbs Also See for igh:
Table of Contents

Advertisement

Quick Links

Download this manual See also: User Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the igh and is the answer not in the manual?

Questions and answers

Related Manuals for Green Point igh

Summary of Contents for Green Point igh

  • Page 2 Green Point products are constructed with careful attention to detail, using only h quality materials, assuring peak performance over time.
  • Page 3 Important Read before installing 1. Install in accordance with all national and local electrical codes and local regulations of your country. 2. The products of the system range are designed to be used and installed in domestic and similar environments where there is no need for special protections against the ingress of water.

  • Page 4: System Overview

     Smart Switch  Sensor  Keypad  IR Bridge  Internet Gateway System Connectivity Autonomous Room Autonomous Room Thin Gateway Client Dimmer Sensor Switch Sense Switch Shutter Keypad Switch Power Switch Bridg Internet network Igh RF protocol Ring...

  • Page 5: Key Features

    Functions Key features:  PIR – Motion Sensor  Light intensity meter  Thermometer  Real time clock  RF communication with units. Operating Modes There are 2 operating modes, Normal and Disabled, that can be toggled manually on the bottom part of the sensor.
  • Page 6 Low Power indication: When the battery is low, the red LED light will turn on. systems on smartphones and tablets will also indicate a low battery. When this happens expose the sensor to sunlight for a while. If this problem remains, contact the products support center.
  • Page 7 Mounting Select a mounting location for the Wireless Motion Sensor. When choosing an appropriate location, the following should be considered: • Detection angles (refer to diagram ) • A mounting height of 1.8m is recommended • RF range • Shielding the motion sensor from direct sunlight, if possible, for better motion- sensing reliability.
  • Page 8 Installation 1. Verify that the operation mode is on Disabled – 0 (Diagram 1). 2. Activate the Sensor power. The power switch is located on the back of the sensor behind the mounting doors. Use a thin sharp object to move the sliding switch. 3.
  • Page 9 the range, tilt the sensor upward. You can use two or more Wireless Motion Sensors to improve detection coverage in an area. Multiple motion sensors can cascade to act together as a single motion sensing device, thus increasing the detection coverage. The “motion detected” event will happen when any of the cascaded motion sensors detect motion.

  • Page 10: Specifications

    Signal (Frequency): ISM BAND (433.050 - 434.790 MHz) WARRANTY Green Point Products warrants this product to be free from manufacturing defects for a period of one year from the original date of consumer purchase. This warranty is limited to the repair...

  • Page 11: Regulatory Compliance

    Regulatory Compliance The IGHS- Sensor unit has been tested and found to comply with specifications for CE marking and standards per EMC and radio communications and safety Compliance. SAFTEY EN 60950-1: 2006 + A11: 2009 + A1: 2010 + A12: 2011. Information technology equipment - Safety - Part 1: General requirements ETSI EN301489-1 and EN301489-3 Electromagnetic compatibility and Radio...

Table of Contents