Oven - Haier HOR54B5MGW1 User Manual

OPERATION
Ignition without an ignitor
 Light a match.

Press in the knob to the end and turn
it left to the "large flame" position ，
 Ignite gas with a match.，

Set required flame size (e.g.
"economical" )，
 Switch off the burner after finishing
cooking, turning the knob right (to the
off position ).
Knob ignition

Press in the knob to the end and turn
it left to the "large flame" position ，

Hold until gas is lit，

After the flame is lighted release the
pressure on the knob and set a
required flame size.
Caution!
In cooker models equipped with a surface
burner safety valve, hold the knob pressed
down to the end when igniting for 10
seconds at the "large flame" position to
activate the safety device.
If the ignition device is out of order, either
due to power failure or humid ignition
device, use a match or a lighter to ignite
the gas.
● Keep the button pressed for
approximately 10 second after ignition
to stabilize the flame.
● If you failed to ignite the burner after
15 seconds. Shut the burner off and
wait for at least one minute before the
next attempt.
13
Selection of the approprite flame
A correctly adjusted burner has a light blue
flame with a clearly visible internal cone.
Selection of flame size depends on the
position of the burner knob which has been
set:
Large flame
Small flame ("economical flame")
Burner switched off (gas supply is cut
off)
Depending on requirements, flame size
can be set in a continuous manner.
WRONG RIGHT
Caution!
● Button positions between
in
not recommended. In these positions
the flame is not stabilized and may be
extinguished.
● If the flame goes out repeat the
procedure.
● If the burner flame goes out (for
whatever reason), shut the burner off
and wait for at least one minute before
next attempt.
● Before igniting the burners cover them
with appropriate cookware.
OPERATION
Operation of the burner protection
valve
Some models are equipped with an
automatic system that cuts off gas supply
to a burner when the flame has
disappeared.
This system protects the cooker against
gas leakage when the flame on a burner
goes out e.g. in case of spillage.
The user's intervention is needed to
re-ignite the burner.

Oven

Oven functions and operation
265° 255° 215°
235°
are
Oven is equipped with gas valve with
temperature regulator and anti-outflow
protection. To ignite the oven, as in the
description below, keep down the pressed
knob during about 3 s, this is the time
necessary to warm the sensor and to make
the protection function. If the flame goes
out, repeat ignition operations after a lapse
of 3 sec. if the flame does not start burning
within 10 sec., repeat the ignition operation
after lapse of about 1 min, i.e. after the
oven ventilation.
To ignite the bottom burner
 Strike a match,
 Press down the knob to the stop and
turn left to the position corresponding
to the temperature chosen,
 Put the match to the ignition opening
(see the figure below) and keep the
knob pressed down about 3 sec. from
the gas ignition moment . if the flame
has gone out, repeat the ignition
operation after lapse of 3 sec.
150°
195° 160°
175°
Caution!
The temperature control is possible
at closed oven door only.
Turn the knob right to the stop in order
to turn the oven off.
Turn the knob to the large flame position
"8",when ignite the oven.Turn the knob to
the selected position after the stable
condition is formed.
14