ThermoWorks thermadata Setup Manual

Setting up your ThermaData WiFi Logger

Connecting the device to your network using a Wi-Fi connected PC and USB cable

• Download and open ThermaData Studio and select 'ThermaData WiFi'. (Available at www.thermoworks.com/software)

• Connect ThermaData WiFi logger to PC using the provided USB cable. The following menu items will then become active.

• Click on 'Configure WiFi.'

• Select desired Wi-Fi network from the 'Network name' drop down menu and enter the necessary details. (Wait for green bar to load across,

while the software scans for available networks.) Click on 'Set WiFi network'

NOTE: Most networks use WPA2 encryption, but check with your network admin to be sure. The password is your network

password and is case sensitive.

• The logger will connect and then display a Wi-Fi signal indicator and a cloud icon in the top left-hand

corner of the ThermaData WiFi logger's LCD, indicating a successful connection.

• If you've successfully connected to the Wi-Fi, you can skip to page 3 'Pairing a device.'

(Requires Windows PC or laptop connected to Wi-Fi.)

Table of Contents

Do you have a question about the thermadata and is the answer not in the manual?

Page 1 (Requires Windows PC or laptop connected to Wi-Fi.) • Download and open ThermaData Studio and select ‘ThermaData WiFi’. (Available at www.thermoworks.com/software) • Connect ThermaData WiFi logger to PC using the provided USB cable. The following menu items will then become active. • Click on ‘Configure WiFi.’...
Page 2 IMPORTANT: This page will only load correctly if the logger still says ‘Set UP’ and the device is connected to the logger’s ‘network’ as shown above. • You will now be directed to a ThermaData WiFi configuration page. Follow the on-screen instructions on your mobile device. • Select the appropriate Wi-Fi network that •...
Page 3 (This can be done on any internet connected PC running ThermaData Studio.) • From the ThermaData WiFi tab, click ‘My Instruments’ and input the logger’s serial number in the bottom right-hand corner. (This can be found on the rear label of the logger and reads as ‘D12345678.’)
Page 4 Please note that if you have a Gmail account you can use that account to establish your Email-Server without populating the other server fields. NOTE: ThermaData Studio manages your free wireless alerts. If you choose to be alerted remotely to alarms, you’ll need to keep ThermaData Studio running so it can send out the alerts.