Pride Jazzy 610 Series Owner's Manual page 26

V . C O M F O R T
Controller Position
You can move the controller in toward or out away from
the armrest, or change the position of the controller for ei-
ther left-hand or right-hand use.
MANDATORY! Prevent controller harness
damage! Avoid routing the controller
harness on the outside of the armrest
pad. Route the har ness under the
armrest or toward the inside of the
ar mrest pad. Use cor rect tie-down
points for the controller harness to
prevent the harness from getting caught
in the drive tyres, pinched in the seat
frame or damaged when passing
through doorways.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket. See
figure 16.
3. Slide the controller into or out of the armrest to the
desired position.
4. Tighten the setscrew to secure the controller.
To change the controller position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners. See figure 6.
3. Remove the rear shroud.
4. Unplug the controller connector(s) from the power base.
5. Cut the wire tie(s) securing the controller cable to the
armrest.
6. Flip up the armrest so that it is perpendicular to the floor.
7. Loosen the setscrew under the armrest. See figure 16.
8. Slide the controller out of the armrest.
9. Loosen the setscrew under the other armrest.
10. Place the controller in the other armrest.
11. Tighten the setscrew to secure the controller.
12. Use a wire tie to secure the controller cable to the armrest.
13. Plug the controller connector(s) into the power base.
14. Reinstall the rear shroud and tighten the fasteners.
NOTE: If your power chair is equipped with a Syn-
ergy or TRU-Balance Seating System, refer to the con-
troller adjustment information contained in separate
manuals.
26
A D J U S T M E N T S
Figure 16. Underside of Armrest
www.pridemobility.com
CONTROLLER BRACKET
SETSCREW
Jazzy 610 Series