Advertisement
Assembly
• Insert and "snap" the breakaway
tail into the RC snake's body.
• Hint: The RC snake's breakaway tail
may detach from the body during
play. If this happens, simply insert
and "snap" the breakaway tail into
the body.
Battery Tips
• Do not mix old and new batteries.
• Do not mix different types of batteries:
alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium).
• Remove the batteries during long
periods of non-use. Always remove
exhausted batteries from the toy.
Battery leakage and corrosion can
damage this toy. Dispose of
battery(ies) safely.
• Never short circuit the battery
terminals.
• Non-rechargeable batteries are not
to be recharged.
• Only batteries of the same or
equivalent type as recommended in
the "Battery Installation/Replacement"
instructions are to be used.
• If removable rechargeable batteries
are used, they are only to be charged
under adult supervision.
• Rechargeable batteries are to be
removed from the toy before they
are charged.
• If you use a battery charger, it should
be examined regularly for damage
to the cord, plug, enclosure and
other parts. Do not use a damaged
battery charger until it has been
properly repaired.
Body
Breakaway Tail
1
Battery Installation
• Hint: The 9 volt (6LR61) battery in the remote has a longer life than the "C"
batteries in the RC snake. You may need to change the "C" batteries more often
than the 9 volt battery.
• When you notice that the RC snake does not respond to the remote, try replacing
the batteries in the RC snake before replacing the batteries in the remote.
• When the RC snake stops working or works erratically, it's time for an adult to
replace the batteries!
Remote
9V (6LR61)
Shown Actual Size
Battery
Compartment
Door
• Locate the battery compartment on the bottom of the remote and bottom of
the RC snake.
• Loosen the screw in each battery compartment door with a Phillips
screwdriver. Lift to remove each door. (The screw will remain in each door.)
• Snap the battery into the battery contacts, as shown. Insert the batteries into
the battery compartment.
• Replace each battery compartment door and tighten each screw with a
Phillips screwdriver. Do not over-tighten.
RC Snake
1.5Vx 4
"C" (LR14)
Shown Actual Size
Battery
Compartment
Door
2
Advertisement
