Related Manuals for AEI PROTECT-ON SYSTEMS DK-2310
Summary of Contents for AEI PROTECT-ON SYSTEMS DK-2310
- Page 1 WIRELESS DIGITAL ACCESS CONTROL KEYPAD RoHS Compliance DK-2310 Operating Instructions FOR ELECTRIC LOCK AND SECURITY SYSTEM AEI PROTECT-ON SYSTEMS LIMITED www.apo-hk.com VERSION: 05/2012...
- Page 2 ............... 1 0 FEATURE PROGRAMMING is also built-in with a 2-channel receiver compatible with the DK-2310 to control the door lock and the built-in door chime. A split-decoder compatible with our DK-2800 series keypads for split-decoded .
-
Page 3: Introduction
FUNCTION MODES VALIDATION The DK-2310 is a 9V battery operated 433Mhz wireless keypad designed to work in conjunction with the receiver for access control. The products from us with receiver include the DA-2311 self- contained access controller, the AD-2322 controller power pack, and the DA-2800 split-decoded CODE FOR BACK-LIT MODE access controller. -
Page 4: Installation
INSTALLATION USER CODE ENTRY MODE - Auto or Manual Mode (Location 7) LOCATIONS ENTRY MODES VALIDATION DK-2310 Plastic Back Box Faceplate + USER CODE ENTRY MODES with Battery Case Fixing Frame Circuit Module Two entry modes are available for owner’s selection. - Page 5 THE CIRCUIT BOARD VISITOR CODES (FOR OUTPUT 1 ONLY) (Locations 5) The Visitor Codes are temporary codes for operating Output 1 only. They can be programmed as one time codes or codes with valid time limit. The Visitor Codes will be cleared automatically after use if they are one time codes, or, when the allowed time expires.
-
Page 6: Power Up The Keypad
RECORD A SUPER USER CODE ( Location 4) POWER UP THE KEYPAD The Super User Code is prepared for the owner to simply use it to operate the three outputs of the After snapping the 9V battery on the battery clip, the keypad is in the power up delay of one minute system and to effect the prohibit function for Output 1. -
Page 7: Operation
FEATURE PROGRAMMING OPERATION After setting the system into programming mode, the feature values can be put into the system one by After the keypad and keyfob are registered in the receiver it can be used for door release in access one with the Programming Locations. -
Page 8: Set System In Programming Mode Or Refresh The System
SET SYSTEM IN PROGRAMMING MODE OR REFRESH THE SYSTEM REFRESH THE SYSTEM WITH THE “DEFAULT CODE” --- 9 9 9 9 The system can be refreshed with the Default Code to clear all the old data. SET SYSTEM INTO PROGRAMMING MODE WITH THE MASTER CODE It is necessary to set the system into programming mode to accept the new programming values.
Need help?
Do you have a question about the DK-2310 and is the answer not in the manual?
Questions and answers