Egnater M4 Quick Start Manual

Install the modules (up to four) by firmly inserting the module into the slot. Then tighten the two
captive thumbscrews until the module panel is pulled in flush with the rack panel. Always install a
blank "filler" panel into any unused module slots. To remove a module, turn the two thumbscrews
counter clockwise until they are loose. Grasp the thumbscrews and pull out.
IT IS STRONGLY RECOMMENDED THAT YOU TURN THE PREAMP OFF BEFORE
CHANGING MODULES!

Front Panel:

INPUT:
CHANNEL:
MASTER:
Rear Panel:
INPUT:
OUTPUTS:
POWER:
GROUND:
MIDI IN:
MIDI THRU:
AC INLET:
Egnater
Modular
Tube Preamp
Quick Start
Plug your guitar in here. This jack takes priority over the rear panel input.
Selects the desired module.
The overall level for all channels
Same as the front panel input.
Two ¼" parallel outputs to connect to effects or power amplifier inputs.
AC mains on/off.
This switch separates the circuit ground from the chassis ground.
Typically set for NORMAL when free standing and LIFT when used in a
grounded rack setup. Set for the least amount of audible hum.
For channel selection. Use the EGNATER pedal or any midi controller.
Passes the signal from the MIDI IN jack for controlling other devices.
Accepts a standard IEC power cord. Remove the fuse holder cap using a
small blade screwdriver. Insert the cap so that the arrow points to the
correct voltage. Be sure to use the proper value fuse as indicated on the
rear panel..
M4
.