Advertisement
Quick Links
Caution: Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment dose cause harmful interference to radio or
television reception. Which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures :
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help
* Product Features
Slim & deluxe design
Built in power supply
One touch assembly without screws
Easy to use, carry and travel with it
Plug & Play and Hot Plugging
Scheduling auto back-up software
* Caution
New hard disk requires FDISK and Formatting. SPIO can't be detected in the computer without this process.
Do not drop or aggressively handle the SPIO. It may cause damage to the hard disk.
Avoid exposing the SPIO to
Do not remove or disconnect the SPIO from PC while the SPIO is transferring the data. It may cause damage to
User's Manual
FCC Compliance Statement
.
the magnetic like a speaker and humidity
1
SPIO
Mobile Hard Disk Drive
. It may cause damage to the hard disk..
Advertisement
Related Manuals for Value Plus SPIO 352
Summary of Contents for Value Plus SPIO 352
-
Page 1: Product Features
SPIO Mobile Hard Disk Drive User’s Manual FCC Compliance Statement Caution: Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE : This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC Rules. - Page 2 hard disk. <On the data loss resulted from ignoring above notes, Valueplus Inc. is not responsible for it.> < Please refer to the Installation Procedure > Hardware Installation (4 page) Driver Installation (5 page) Partition and format (6 page) Ready to Use (7 page)
- Page 3 < Contents > Product features and caution 1. Specification 2. System Requirements 3. Installation 1) Hardware installation 2) Driver installation 2) Partition and format 3) Ready to use 4. How to use HardCopy (Auto-scheduling backup software) ? 5. Trouble Shooting 6.
- Page 4 Installation 1) Hardware installation 1.Prepare the SPIO 352 and HDD(3.5” IDE type for general computer). 2.Push down the hook, pull the slide bar, and open the case. 3.Connect the 40pin IDE cable of PCB and 4pin of power cable each to the 40pin IDE connector of HDD and 4pin power connector.
- Page 5 2)Driver installation for Windows 98 User Before connecting the SPIO to your computer, double click the file “USB-IDE98_v1016B.exe”, and install the driver at your computer. Follow the installation process in Figure 1~3 Figure 1. After double click “USB-IDE98_v1016B.exe”, InstallShield Wizard will start. Figure 2.
- Page 6 <Driver Installation under Windows ME / 2000 / XP > SPIO is automatically detected without driver installation under Windows ME, 2000, XP. 3) Partition and Format *Caution : The driver should be Installed before partition and Format. To partition new hard disk, run the fdisk command. 1)Fdisk and format of new hard disk at windows 98 / ME a.Install the driver after connecting the product to computer (Driver is installed automatically under Windows ME) b.After driver installation, select and click start ->...
- Page 7 -> choose Disk Management and left click a.Right click the Not allotted drive in Disk management -> execute the Making partition. b. When partition magician is started, click the Next. c. If the main partition(P) is checked. Then click the Next. d.
- Page 8 Drag & Drop the SPIO icon to the trash icon on Desktop. 4. How to use HardCopy (Auto-scheduling backup software) ? Insert the program into CD-ROM Drive. There is a directory of [Hardcopy]. Double click on the “Hardcopy.exe” icon. Click OK to install the Hardcopy under the default directory. Don’t need to restart your computer. You are ready to use Hardcopy.
-
Page 9: Trouble Shooting
4. Advanced: (A) Execute a. File/Folder: backup file and folder. File: backup only file. (B) Folder option: Separate backup time folder is created for each task. (C) Copy option: Can backup hidden file, or backup with file compression. (D) File option: You can backup specific file with selection of file name and file extension. (E) Schedule Time: IF you have chosen a daily schedule, you can specify an exact time of the day when it runs. - Page 10 Warranty registration Product Model Serial No. Date of purchasing Date Month year Place of purchasing Phone Customer Phone Customer address - In case of failure, please contact your local retail shop or customer service center. Valueplus, Inc. TEL : 82-31-717-5880 FAX : 82-31-717-5988 E-mail : vp@valueplus.co.kr, http://www.valueplus.co.kr...