Setup Menu - Sony VPL-VW760ES Operating Instructions Manual

Setup Menu

The Setup menu is used to change the factory preset settings, etc.
Setting items
Status
Language
Menu Position
High Altitude Mode
Remote Start
Network Management
Power Saving
All Reset
Description
Sets whether or not the on-screen display is displayed.
On: Displays on-screen messages and menus.
Off: Turns off the on-screen displays, other than certain menus, a message when turning off the power,
and warning messages.
Selects the language used in the menu and on-screen displays.
You can change the position to display the menu on the projection surface.
Bottom Left: Displays the menu on the bottom left area of the projection surface.
Center: Displays the menu on the center of the projection surface.
Sets the unit to operate at the prevailing atmospheric pressure.
On: Use this setting when using the unit at an altitude of 1,500 m (approx. 4,900 ft) or higher.
Off: Use this setting when using the unit at normal altitudes.
Tip
When this item is set to "On," the fan noise becomes slightly louder since the fan speed increases.
Sets the Remote Start settings.
On: You can turn on the power from a PC or a terminal which is connected to a network.
Off: Turns off the Remote Start function.
Tips
• To use the function, the unit should be connected to the network in advance (page 30).
• To turn on the power with the Remote Start function, a special command should be sent from a PC or
a terminal. For details, consult with qualified Sony personnel.
Note
When the Remote Start is set to "On," the standby power requirement will increase. When Network
Management is set to "On," Remote Start is automatically fixed at "Off" and is not displayed in the
menu.
On: Set when connected to the network and continuously communicating with the projector control
equipment.
Off: Turns off the Network Management function.
Note
When Network Management is set to "On," the network function is continuously enabled. Set Network
Management to "Off" for normal use. If you set to "On," the power consumption increases.
Sets the Power Saving mode.
Standby: If no signal is input for 10 minutes, power is turned off automatically and the projector goes
into standby mode.
Off: Disables the Power Saving function.
All settings are initialized to their factory preset values.
25