Advertisement
TROUBLESHOOTING
F
Problem
No Mist or
Power supply is not connected
mist volume
significantly
Water is lower than the water
reduced
Water is exceeding the max
There may be a build-up of oil on
Unit will not
There is an insufficient amount of
switch on
The Power cable may not be
Water is
The cover is not positioned
leaking from
the product
The unit has been tipped or
The temperature is low or there is
The intensity and amount of mist may vary, but this is not unusual and should not be considered
as a fault. Factors that may affect this include water type, humidity, temperature, air currents etc.
Possible Cause
level sensor
water level line
the ceramic disc
Mist outlet is blocked
water in the tank.
connected properly
correctly
knocked over
high humidity
Solution
Plug in the power adaptor and press the
mist button
Refill the tank with ordinary tap water. Take care
not to fill past the max water level line
Carefully pour out excess water via the water
discharge groove
Clean the ceramic disc with water and a clean
Clean the mist outlet by thoroughly cleaning the
inside of the cover with clean water
Fill the water tank with water up to the max
water level line. Do not over fill.
Disconnect the cable and try connecting
properly.
Remove cover and replace correctly allowing
mist to release correctly.
Follow the accidental leakage instructions.
Under these conditions the mist can sometimes
condense into water droplets.
cloth
Advertisement
