Feature "A" Programming - Silencer 50SL Installation Manual

FEATURE "A" PROGRAMMING

1. Turn the Ignition 'switch "ON/OFF" 3 times and stay in the "OFF" position.
2. Push the Programming switch 3 times (holding in on the 3rd push) until a long chirp is heard;
then release the Programming switch. You are now in the feature "A" programming mode.
3. Press and release the transmitter button with the Icon corresponding to the feature that you want to program.
a. The (optional) horn chirps and the LED will flash then pause indicating a previous setting.
b. The factory default settings are always [1] LED flash, [1] horn chirp.
4. Depress the transmitter button icon again to change the feature. Simply keep re-depressing the
transmitter button icon again until the module advances to your desired setting.
5. Depress the next desired transmitter icon button corresponding to the feature you want to program.
(*) The Horn must be connected to hear the programming chirps.
Press One Chirp /
Transmitter LED One Pulse
Button Factory Default Setting
White/Blue = 1 Pulse
1.
Remote Start
Pink Wire = Factory Security
2.
Disarm Signal Output
ADS DBI Protocol
3.
Without ignition controlled
4.
door locks & unlocks
Brown Wire = Horn Output
5. +
(-) Output
Button- One push
6. +
Remote Start
Horn Chirp Duration
7. +
Standard 20 mS
Exit: Turn Ignition to the "ON" position, or leave it for 15 seconds. 3 long chirps & 3 parking light flashes will confirm exit.
IM_FULL_50SL_REV-A
Two Chirps /
LED Two Pulse
White/Blue = 3 Pulse
Remote Start
Pink Wire = Start Status (Shock
Sensor Bypass Control) Output
Fortin DBI Protocol
Ignition Controlled Door Locks
& Unlocks
Brown Wire = Rearm Signal
(-) Output
Button-Two Push Remote
Start- Safety Start Feature
Horn Chirp Duration
30 mS
12
Three Chirps/
LED Three Pulse
White/Blue = 2 Pulse
Remote Start
Pink Wire = 20 Second
Ground Out Key Sensor
By-pass
Ignition Controlled Locks Only
Horn Chirp Duration
10 mS