Page 2
Connecting to Other Devices ..................6 Making and Receiving Calls ..................6 Understanding Your Headset Indicators..............8 III. TROUBLESHOOTING-----------------------------------------------------------------------------------9 IV. REGULATORY COMPLIANCE NOTICES--------------------------------------------------------10 -------------------------10 FCC CLASS B EQUIPMENT NOTICE – PBH300 BLUETOOTH HEADSET European CE Notice Certification and Safety Approvals/General Information------11 V. Limited Warranty-----------------------------------------------------------------12...
I. Introduction Thank you for purchasing this PBH300 Bluetooth Headset. The Bluetooth headset is the next generation of mobile accessories – a comfortable and portable Bluetooth headset for hands free communication with your Bluetooth enabled mobile phone. The headset allows the user to communicate between various Bluetooth devices, including cellular phones, personal digital assistants, and laptop computers.
II. Start Use Headset Charging the Battery For first time used, before you can use your headset, you need to charge its self-contained battery for two hours. Recharging-When you see LED at glimmering red light, the headset battery needs to be recharged. It will take approximately 2 hours to fully charge the battery.
5. When the scan is complete, the phone displays the devices found. 6. Select the PBH300 from the discovered devices list and confirm following the on screen prompts. 7. When prompted by the phone, enter the pass code “0000” and confirm to pair the headset with the phone.
Controlling Headset Volume Increasing and Decreasing Volume " To increase speaker or ring tone volume, press the volume up button repeatedly until it reaches the desired volume level you desired. To decrease speaker or ring tone volume, press the volume down button repeatedly until it reaches volume level you desired.
Page 7
Action Hands Free Profile Headset Profile Function *Long press is more than 1 second and less than 4 second. *Short press is less than 1 second Enter Pairing ● Long press Volume Up ● Long press Volume Up (Configuration) Mode Make a Voice Dial Call ●...
Understanding Your Headset Indicators Audible Function Action Key Visual Indicators Indicators Power On Press MFB for 5 Blue light – five short Low to high seconds flashes Power Off Press MFB for 5 Red light – five short High to low seconds flashes Active...
Troubleshooting III. 1. Can’t turn the Bluetooth headset on. Ensure the Bluetooth headset is properly charged. 2. The headset can’t pair with Bluetooth mobile phone. Turn both Headset and mobile phone off then perform the Pairing procedure again and refer to the procedures described in your mobile phones manual. 3.
IV. Regulatory Compliance Notices FCC Class B Equipment Notice – PBH300 Bluetooth Headset This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
European CE Notice Certification and Safety Approvals/General Information This product is CE marked according to the provisions of the R & TTE Directive (99/5/EC). Hereby B.A.E. declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. Please note that this product uses radio frequency bands not harmonized within the European Union (“EU”).
V. Limited Warranty The manufacturer warrants that the Bluetooth Headset shall conform to her published specifications, which maybe subject to change, and remain free from defects in materials and workmanship under normal, proper and intended use within warranty time, provide that proof of purchase be furnished with any returned equipment.
Need help?
Do you have a question about the PBH300 and is the answer not in the manual?
Questions and answers